Abstract:Cosmic microwave background (CMB) experiments have deployed focal planes with transition edge sensor (TES) bolometers cooled to sub-Kelvin temperatures by multiplexing the readout of many TES channels onto a single pair of wires. Digital Frequency-domain Multiplexing (DfMux) is a multiplexing technique used in many CMB polarization experiments, such as the Simons Array, SPT-3 G, and EBEX. The DfMux system studied here uses LC filters with resonant frequencies ranging from 1.5 to 4.5 MHz connected to an array of TESs. Each detector has an amplitude-modulated carrier tone at the resonant frequency of its accompanying LC resonator. The signal is recovered via quadrature demodulation where the in-phase (I) component of the demodulated current is in phase with the complex admittance of the circuit and the quadrature (Q) component is orthogonal to I. Observed excess current noise in the Q component is consistent with fluctuations in the resonant frequency. This noise has been shown to be non-orthogonal to the phase of the detector's responsivity. We present a detailed analysis of the phase of responsivity of the TES and noise sources in our DfMux readout system. Further, we investigate how modifications to the TES operating resistance and bias frequency can affect the phase of noise relative to the phase of the detector responsivity, using data from Simons Array to evaluate our predictions. We find that both the phase of responsivity and phase of noise are functions of the two tuning parameters, which can be purposefully selected to maximize signal-to-noise (SNR) ratio.

Performance of a Low-Parasitic Frequency-Domain Multiplexing Readout

Recent Advances in Frequency-Multiplexed TES Readout: Vastly Reduced Parasitics and an Increase in Multiplexing Factor with sub-Kelvin SQUIDs

Frequency Multiplexed SQUID Readout of Large Bolometer Arrays for Cosmic Microwave Background Measurements

Frequency division multiplexing readout of a transition edge sensor bolometer array with microstrip-type electrical bias lines

A 153μw 26nv/√hz Readout Circuit with BW and Power Scalability Using Capacitively-Coupled Chopper Floating Inverter Amplifier Embedded in a Discrete-Time ΔΣ Modulator

Improved Performance of TES Bolometers using Digital Feedback

Crosstalk Effects in Microwave SQUID Multiplexed TES Bolometer Readout

Performance and characterization of the SPT-3G digital frequency-domain multiplexed readout system using an improved noise and crosstalk model

Understanding the Phase of Responsivity and Noise Sources in Frequency-Domain Multiplexed Readout of Transition Edge Sensor Bolometers

Multiplexed readout of ultrasensitive bolometers

The Simons Observatory Microwave SQUID Multiplexing Detector Module Design

Simulation and Measurement of Out-of-Band Resonances for the FDM Readout of a TES Bolometer

Multiplexed readout demonstration of a TES-based detector array in a resistance locked loop

Results and Limits of Time Division Multiplexing for the BICEP Array High Frequency Receivers

Results and Limits of Time-Division Multiplexing for the BICEP Array High-Frequency Receivers

Electrical cross talk of a frequency division multiplexing readout for a transition edge sensor bolometer array

Spectral Engineering for Optimal Signal Performance in the Microwave SQUID Multiplexer

Optimal Demodulation Domain for Microwave SQUID Multiplexers in Presence of Readout System Noise

Developments of highly-multiplexed, multi-chroic pixels for Balloon-Borne Platforms

Digital Frequency Domain Multiplexer for mm-Wavelength Telescopes