Abstract:AC pulse heating is a promising preheating method for lithium-ion batteries due to its low energy cost and high efficiency. To avoid the lithium plating in the AC heating, upper bound of heating current (UBHC) should be obtained. In this paper, the dual RC model is developed, and coupled with the thermal model to predict the battery temperature and potential of negative electrode (PNE). PNE = 0 V is used as the lithium plating criteria. If the PNE falls to 0 V during the heating process, the lithium plating is triggered, and the corresponding pulse amplitude is the UBHC. Moreover, because the UBHC increases with the battery temperature, the pulse amplitude should be automatically raised to increase the heating efficiency. When the battery temperature is too low, the UBHC is so small that the AC pulse heating is inapplicable. Through the self-adaptive AC pulse based on the UBHC, the heat strategy is built, and the heating time is calculated. The total heating time reached by the proposed strategy increases with the increment of the initial SOC, and it falls with the decrease of the initial battery temperature. Moreover, the heating time has a temperature limit. If the battery temperature is lower than the limit, the battery cannot be heated to the target temperature in the required time. The proposed strategy is applied to heating the battery at the different SOCs, and its performance is compared to the constant amplitude pulse. In the same heating time, the battery temperature achieved by the proposed strategy is at least 7.6 °C higher than the constant amplitude pulse. Moreover, the UBHC is enlarged by 10% to prove the original UBHC can reduce the degradation. The cyclic heating experiment shows that the 110% UBHC reaches a capacity loss of 0.49 Ah after 60 heating cycles and that of the original UBHC is only 0.1 Ah.

Temperature-Adaptive Alternating Current Preheating of Lithium-Ion Batteries with Lithium Deposition Prevention

Internal heating of lithium-ion batteries using alternating current based on the heat generation model in frequency domain

Battery heating for lithium-ion batteries based on multi-stage alternative currents

An Internal Heating Strategy for Lithium-Ion Batteries Without Lithium Plating Based on Self-Adaptive Alternating Current Pulse

Experimental study on the mechanism of frequency-dependent heat in AC preheating of lithium-ion battery at low temperature

A health-aware AC heating strategy with lithium plating criterion for batteries at low temperatures

A variable-frequency self-heating strategy for lithium-ion batteries based on an electrochemical impedance-thermal coupling model applicable to a wide frequency range

A Square Wave Alternating Current Preheating with High Applicability and Effectiveness of Preventing Lithium Plating

Frequency varying heating strategy for lithium-ion battery rapid preheating under subzero temperature considering the limitation of on-board current

Experimental Study on the Mechanism of Extra-Heat in High-Frequency Preheating of Lithium-Ion Battery at Low Temperature

Thermal Characteristics Investigation of Lithium-Ion Battery Under High-Frequency AC Excitation in Low-Temperature Environment

Analysis of control strategies in alternating current preheating of lithium-ion cell

A Review of AC Heating Technique for Lithium-Ion Batteries

Rapid and deposition‐free preheating of lithium‐ion cell with square wave current

Distribution of Relaxation Times-Based Analysis of Aging Mechanisms and Prediction of Heating Domain for Alternating Current Pulse Self-Heating Lithium-Ion Batteries

High-Frequency AC Heating Strategy of Electric Vehicle Power Battery Pack in Low-Temperature Environment

Frequency-Variable Resonant Self-Heating Technique for Lithium-Ion Batteries at Low Temperature

A Novel DC-AC Fast Charging Technology for Lithium-Ion Power Battery at Low-Temperatures

An optimized internal heating strategy based on bidirectional pulsed current for lithium-ion battery at low temperature

Targeting the low-temperature performance degradation of lithium-ion batteries: a non-destructive bidirectional pulse current heating framework

A rapid lithium-ion battery heating method based on bidirectional pulsed current: Heating effect and impact on battery life