Abstract:Dynamic contact angle measurement; as a standard method for surface wettability analysis, is usually conducted through the analysis of sessile drops formed following the low rate injection of fluid from beneath through a drilled hole via an injection needle. However, understanding/characterizing the changes of drop contact angle from the point where the flat solid surface begins is not well discussed yet. Moreover, during the evaluation of size-dependent behavior of contact angle of millimeter-scale drops, the effect of the drilled hole is ignored. In this regard, in the current study, the experimental and thermodynamic characterizations of the sessile drop advancing contact angle measurements for a liquid-solid-air system are presented. To do this, a set of dynamic contact angle experiments for a water-calcite-air system with different devised hole diameters and roughness is conducted, and Gibbs free energy analysis is then utilized to propose a modeling scheme. Experimental results revealed a transient region from zero infinite contact angle at the hole to infinite contact angle of the solid surface, which was equal to 74.61° and 69.05° for nanoscale, and microscale surface roughness. In addition, it was shown that with a decrease in the hole diameter, the transient region met a lower value of contact angle at different dimensionless volumes. The result of higher advancing contact angle measured for the system with smaller drilled hole diameter was attributed to higher contact-line velocity. However, the assumption of low rate advancing contact angle was not violated for the hole diameter larger than 1.4 mm. Numerical studies demonstrated that in the case of zero line tension, two straight lines with positive slop could be fitted to the data; attributed to drilled hole effect. Besides, it was concluded that this behavior should not be interpreted as a negative line tension effect. The obtained values of line tension and equilibrium advancing contact angle, as matching parameters, were in agreement with those reported in the previous studies. Results of this work could help for better analyzing the size-dependent behavior of millimeter-scale drop through a suggested size-dependent model.

Laboratory measuring of contact angles for liquid/solid surface and analysis with artificial neural network

Compare numerical modeling and improved understanding of dynamic sessile drop contact angle analysis in Liquid-Solid-Gas system

Accurate and robust static hydrophobic contact angle measurements using machine learning

Reliable determination of contact angle from the height and volume of sessile drops

Machine learning approach for the prediction of surface tension of binary mixtures containing ionic liquids using σ‐profile descriptors

Convolutional Neural Network (CNN)-Based Measurement of Properties in Liquid–Liquid Systems

Surface tension prediction of pure organic components: An artificial neural network approach

Designing artificial neural network of nanoparticle diameter and solid–fluid interfacial layer on single‐walled carbon nanotubes/ethylene glycol nanofluid flow on thin slendering needles

Assessment of Direct Image Processing Methods to Measure the Apparent Contact Angle of Liquid Drops

J0230203 Analytical consideration of droplet wettability on solid surfaces

Data-driven time-dependent state estimation for interfacial fluid mechanics in evaporating droplets

Apparent Contact Angle and Contact Angle Hysteresis on Liquid Infused Surfaces

Simple relations for wettability of a droplet on a low-surface-energy solid

Experimental and Theoretical Investigation of Contact-Angle Variation for Water–ethanol Mixture Droplets on a Low-Surface-energy Solid

Surface tension of binary and ternary mixtures mapping with ASP and UNIFAC models based on machine learning

Numerical Analysis of Anisotropic Wetting of Chemically Striped Surfaces.

Comparison of Artificial Neural Networks and Genetic Algorithms for Predicting Liquid Sloshing Parameters

Hybrid AI-Analytical Modeling of Droplet Dynamics on Inclined Heterogeneous Surfaces

A non-iterative method to evaluate surface tension and contact angle simultaneously by a sessile drop in gravity using universal figures

Contact angle measurement for polymeric membranes: software selection for ease of use and precision

Through-Drop Imaging of Liquid-Solid Interfaces: From Contact Angle Variations Along the Droplet Perimeter to Mapping of Contact Angles Across a Surface