Abstract:The explicit methods analysis solver LS-DYNA was used to create technology for simulating airbag deployment and plastic airbag lid tear-away in the front passenger seat. The present study clarified the mechanical properties and the transitions in fracture pattern of the material at low temperature plastic this way, an appropriate modeling method was developed and the prediction accuracy of the simulation of airbag lid tear-away on deployment was increased. Tensile testing of the material was carried out where there were differences in thickness of the tear-away section and the fracture characteristics were determined. A material model was created by analyzing changes in fracture characteristics and collapse patterns, taking into consideration the effects of strain and strain rate localization on fracture strain as well as ductile-brittle fracture transition. Next, airbags were subjected to the impactor testing. It was confirmed that the reaction force characteristics with that impactor had a good correlation with the simulation model. Finally, the airbag that matched the reaction force characteristic and the instrument panel model were combined. The simulation result was compared with the experimental results of the tear-away deployment, leading to good correlations with the tear-away process in simulations and experiments. It was also found that the two factors were important with regard to the reproducibility of the progressive tear-away process. They were changes in fracture mode due to the strain rate and strain rate dependence of fracture strainIn addition, it is necessary to pay careful attention to the modeling method due to the varying material thickness. More over prototypes with various significant parameters were created and subjected to accuracy verification. These prototypes also yielded good results for reproducibility. The sufficient accuracy aimed to reduce the number of prototypes in the vehicle development was confirmed.

Fracture and mechanical properties of an impact toughened polypropylene composite: modification for automotive dashboard-airbag application

Development of Plastic Fracture Simulation Technology for Passenger Airbag Tear Line

Ductile crack initiation and growth on a plasticized Polyvinylchloride during air bag deployment

Fracture Toughness and Fracture Mechanisms of PBT/PC/IM Blends PART IV Impact Toughness and Failure Mechanisms of PBT/PC Blends Without Impact Modifier

Study on Mechanical Behaviors of Thermoplastic Materials Used for Automobile Rear Door Panels

Study of Dynamic Failure Behavior of a Type of PC/ABS Composite

Accuracy enhancement for airbag deployment simulations considering the strain rate and temperature-dependent mechanical properties of thermoplastic olefin and polypropylene

Impact Damage Tolerance of Thermoset Composites Reinforced with Hybrid Commingled Yarns

Static and dynamic axial crushing analysis of car frontal impact hybrid absorbers

Fracture mechanism of carbon fiber-reinforced thermoplastic composite laminates under compression after impact

Improving Compression after Impact of T800H/5228A Composite Laminates Through Interlaminate Toughening

Enhancement of the Fracture Toughness of Carbon-Reinforced Plastics by Introducing a Thermoplastic Phase into an Epoxy Matrix

Experimental investigation on constitutive behavior of PVB under impact loading

Influence of UHMWPE fiber and Ti6Al4V metal surface treatments on the low-velocity impact behavior of thermoplastic fiber metal laminates

A New Partially-Infused Fiber Reinforced Thermoplastic Composite for Improving Impact Resistance

Composite Hat Structure Design for Vehicle Safety: Potential Application to B-Pillar and Door Intrusion Beam

Advanced FE Modeling of Vehicle Interior Structures to Enhance the Prediction for Crash Induced Injury Risk of the Occupant

Flexural behaviours and heterogeneous interface fracture in overmoulded multi-material thermoplastic composites

Experimental Determination of Fracture Toughness of Woven/Chopped Glass Fiber Hybrid Reinforced Thermoplastic Composite Laminates

Effect of Composition on Processing and Mechanical Properties of TPE for Injection Molding Automotive Skin

Energy Absorption Capability and Crashworthiness of Composite Material Structures: A Review