Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

The reduction of stress concentrations in adhesive joints with the use of curved aluminum adherends

Evaluation of the cracked lap shear test for mixed-mode fracture toughness estimation of adhesive joints

Delamination prevention of composite joints with asymmetric carbon-fiber reinforced plastic adherends

Material and adhesive effect in adhesively-bonded composite stepped-lap joints

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Statistical analysis of adhesive rod-tube joints under tensile stress for structural applications

Interfacial shear stress analysis in single-lap adhesive joints with similar and dissimilar adherends under dynamic loading

A novel approach for the interfacial stress analysis of composite adhesively bonded joints

On the Intralaminar and Interlaminar Stress Analysis of Adhesive Joints in Plated Beams

A unified strain energy-based fatigue life prediction methodology for composite and metal adhesive joints: Effects of adhesive, geometry and, environment

Influence of 3D printed adherend design on structural performance and vibrational behaviour of adhesively bonded joints

Experimental Investigation of the Mechanical Behavior of Aluminum Adhesive Joints under Mixed-Mode Loading Conditions

Fracture energy and cohesive law analysis of adhesives using a recently developed SCB joint: The influence of joint geometry and mode mixity

Prediction of the critical stress intensity factor of single-lap adhesive joints using a coupled ratio method and an analytical model

Experimental and numerical study on mechanical behavior of 3D printed adhesive joints with polycarbonate substrates

Predicting static strength in adhesively bonded single lap joints using a critical distance based method: Substrate thickness and overlap length effects

Comparative fracture surface analysis of adhesively bonded dissimilar lap joints: Nanosilica effect

Experimental study of the influence of adhesive reinforcement in lap joints for composite structures subjected to mechanical loads

Numerical Studies of Adherend Thickness Influence on the Response of Single Lap Joint under Longitudinal Load

A TWO-DIMENSIONAL SOLUTION FOR UNSYMMETRIC SINGLE-LAP ADHESIVE BONDED JOINTS

Effect of adhesive thickness and surface roughness on the shear strength of aluminium one-component polyurethane adhesive single-lap joints for automotive applications