Abstract:In a typical pressurized water reactor, neutron detectors located outside the reactor core monitor reactor power. In addition, they are also used to measure the reactivity of the control rods. A novel approach to calculate the ex-core neutron detector response in a typical pressurized water reactor using the Monte Carlo technique is presented. A detailed ex-core model of the Krško nuclear power plant was developed using the Monte Carlo neutron transport code MCNP. Due to the location of the ex-core neutron detectors, the hybrid code ADVANTG is used to generate variance reduction parameters to accelerte the convergence of the results outside the reactor core. To use ADVANTG, the fixed neutron source had to be reconstructed from the criticality core calculation. This paper presents the sensitivity analysis of the response of the ex-core detectors to the neutron data libraries used, the description of the fixed neutron source and the ADVANTG parameters. It was found that a pin-wise description of the neutron source for at least two rows of fuel assemblies at the core periphery is necessary for accurate results. Our results show the importance of a correct description of the prompt neutron spectra in the high energy region and the impact this has on the response of the ex-core detectors. The method in which the prompt neutron fission spectra for important fission nuclides are weighted by the calculated reaction rates has been shown to be the best approximation, with deviations from the reference calculation within statistical uncertainty. The effect of nuclear data libraries on the response of the ex-core detector was investigated, and the difference between the ENDF/B-VII.0 and the ENDF/B-VIII.0 nuclear data libraries was ∼11%. When the deficient evaluation of the 56 Fe isotope included in the ENDF/B-VIII.0 nuclear data library was replaced by the improved evaluation from the IAEA INDEN project, the differences decreased to ∼3.7%. In addition, neutron flux redistributions due to control rod movement were investigated and flux redistribution factors were updated using Monte Carlo particle transport methods. The reaction rate redistribution factors obtained with methods presented in this paper are within 1% agreement with the currently used factors.

Evaluation of Reaction Rate Distribution Measurement in the Prototype Fast Reactor Monju

Evaluation of Reaction Rate Distribution for Shielding Region in the Prototype Fast Reactor Monju

Experiments on Central Reaction Rate Ratios and Fission Distributions in the FCA-XXII-1 Assembly Simulating Highly Enriched MOX–Fueled Tight Lattice LWR Cores

A Study of Reactor Neutrino Monitoring at Experimental Fast Reactor JOYO

Comparison and sensitivity analysis of the core characteristics of a sodium-cooled fast breeder reactor with 750 MWe output evaluated by JENDL-4.0 and ADJ2000R

Neutron-Physical and Radiation Characteristics of Different Low Enrichment Fuels (Thorium and Uranium) in a Proposed JRTR Research Reactor

Reactors as a source of antineutrinos: the effect of fuel loading and burnup for mixed oxide fuels

Neutronic Evaluation of LWR Based SMR with TRU Fuel and Comparison with Different Core Configuration of UO2 and MOX Fuel

Measurement and Analysis of Fission Rates in a Spherical Mockup of Uranium and Polyethylene

Gamma and neutron detector performance in a MOX fuel fabrication plant environment

Uncertainty quantification of criticality in light-water-moderated and graphite-reflected core with highly enriched uranium fuel at university teaching and research reactor

Experiments on Criticality and Reactivity Worths in the FCA-XXII-1 Assembly Simulating Highly Enriched MOX Fueled Tight Lattice LWR Cores

Numerical Analysis of Integrative Hot Plenum in Monju Fast Reactor

Determination of neutron flux redistribution factors for a typical pressurized water reactor ex-core measurements using Monte Carlo technique

Simulation of the Measured Reactivity Distributions in the Subcritical MYRRHA Reactor

Evaluation of neutronic parameters for RITM-200 reactor unit considering (238U+235U)O2, (232Th+235U)O2 and (232Th+233U)O2 dispersed fuel using MCU-PTR

Reaction Rate Ratios for Recent Fast Metal Experiments with Large Plutonium Masses

Measurements of effective delayed neutron fraction in a fast neutron reactor using the perturbation method

Neutronic Analysis of Thorium Nitride (Th, U233)N Fuel for 500MWth Gas Cooled Fast Reactor (GFR) Long Life without Refueling

High Fidelity Core Flow Measurement Experiment for an Advanced Research Reactor Using a Real Scale Mockup

Development of Safety-Enhanced Fast Reactor by Using Minor Actinide Bearing Internal Blanket