Experimental study on the melting heat transfer characteristics of a phase change material under mechanical agitation
Yu Xu,Shaohuan Qi,Jiale Wang,Chiyuan Ling
DOI: https://doi.org/10.1016/j.applthermaleng.2024.122423
IF: 6.4
2024-01-18
Applied Thermal Engineering
Abstract:Phase change materials (PCMs) are extensively employed for the thermal management of electronic devices, but their low thermal conductivity often results in slow heat absorption and release in practical applications. Existing improvement measures primarily focus on enhancing heat conduction, while research from the perspective of convection is scarce. Therefore, an experimental study on the melting heat transfer characteristics of n -docosane under mechanical agitation (0–1600 RPM) was conducted at 4.7–34 kW/m 2 . Upon agitation, the heating wall temperature ( T w ) rapidly decreases, while the PCM temperature, heat transfer coefficient and Nusselt number significantly increase, and their variation amplitude is positively correlated with the rotation speed. This can be attributed to enhanced liquid PCM convection and accelerated solid PCM melting. At 8.5 kW/m 2 , the T w at 1600 RPM is approximately 27 °C lower than that at 0 RPM, leading to a fourfold increase in the Nusselt number. T w decreases with increasing rotation diameter, especially at lower rotation speeds. From 30 to 50 mm, the temperature decreases by approximately 13 and 10 °C at 800 and 1600 RPM, respectively. T w changes slightly with increasing rotation height. Agitation can reduce the increase in T w caused by a higher heat flux. Agitation can quadruple the upper limit of heat flux from 8.5 to 34 kW/m 2 while maintaining consistent thermal control requirements. The power consumption of agitation increases as the rotation speed and diameter increase, peaking at 10.1 W. Moreover, after considering the minimum start-up time, T w , and power consumption, the optimal configuration is determined: a rotation height of 10 mm and a rotation diameter of 40 mm for 1600 RPM and 50 mm for 800 RPM. These findings hold significant implications for PCM-based thermal management, particularly in terms of incorporating active convection enhancement.
energy & fuels,engineering, mechanical,thermodynamics,mechanics