Abstract:Al x CoCrFeNi (x = 0.1, 0.5 and 1) high-entropy alloys (HEAs) were prepared using a spark plasma sintering (SPS) technique combined with aerosol powder. Their microstructure and phase constituents were characterized using an X-ray diffractometer and SEM, and their tensile properties, hardness and compactness were tested. The results show that the crystal structure of the Al x CoCrFeNi HEAs changed significantly with the Al content, from the original single face-centered cubic FCC phase (Al0.1CoCrFeNi) to an FCC + BCC structure (Al0.5CoCrFeNi), and then to FCC + BCC + sigma (σ) phase structures (AlCoCrFeNi). Chemical composition analysis showed that the crystal structure transformation was related to the segregation caused by the increased Al content. The hardness of the Al x CoCrFeNi HEAs increases with increasing Al content, and the hardness of AlCoCrFeNi reaches a maximum of 507.3 HV. The tensile properties of the alloy show a trend of first increasing and then decreasing with increasing Al content, and the yield strength, ultimate tensile strength and elongation of the Al0.5CoCrFeNi alloy reach maximum values of 527.4 MP, 943.3 MPa and 28.2%, respectively. The fracture mechanism of the Al0.1CoCrFeNi and Al0.5CoCrFeNi alloys is typical ductile fracture, while that of the AlCoCrFeNi alloy is cleavage fracture. The compactness of the alloy increases with the Al content. The samples were also subjected to high-temperature water vapour corrosion, and corrosion products such as Al3Fe5O12, CoCr2O4 and NiCr2O4 were found in the Al0.1 and Al0.5 alloys, whereas no oxide peaks were detected using XRD for the Al1 alloy. It was also presumed that a very thin alumina film was generated on the surface of the Al1 alloy, preventing the oxidation of the sample, in combination with the analysis of SEM, EDS and XPS behaviour.

Alloying and corrosion characteristics of FeNiMnCu-based high entropy alloys

Corrosion Behavior of FeCrMnxAlCu High-Entropy Alloys in NaOH Solutions

Microstructure and Intergranular Corrosion Sensibility of FeCoNiCrMn High Entropy Alloy

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

Effect of the Aluminium Content of Alxcrfe1.5mnni0.5 High-Entropy Alloys On. the Corrosion Behaviour in Aqueous Environments

Fabrication, Characterization, and Corrosion Behavior of a New Cu40Mn25Al20Fe5Co5Ni5 High-Entropy Alloy in HNO3 Solution

Microstructural evolution, mechanical and corrosion behavior of an Al7.5Co20.5Fe24Ni24Cr24 high‐entropy alloy

Comparative Study of Mechanical and Corrosion Behaviors of Cost-Effective AlCrFeNi High Entropy Alloys

Synthesis and Electrochemical Corrosion Behaviour of High Entropy Alloys

Microstructure, Mechanical and Corrosion Properties of Co- and Cu-free AlxCrFeNi2.5Mo1-x High Entropy Alloys

Microstructure, deformation behavior, and dynamic recrystallization kinetics of FeNiMnCu-based high entropy alloys prepared by mechanical alloying and spark plasma sintering

Mechanical properties and water vapour corrosion behaviour of Al x CoCrFeNi high-entropy alloys

Effect of alloying elements (Mn, Ti, and Mo) on the corrosion behavior of FeCoNiCr-based high entropy alloy in supercritical water

Corrosion resistance of nonequiatomic FeNiCrMnAlx high entropy alloys in hexamine as inhibitor in 3.5% NaCl

Effect of Al content on microstructure, mechanical and corrosion properties of (Fe33Cr36Ni15Co15Ti1)100−x Al x high entropy alloys

Corrosion and electrochemical behavior of CoСrFeNiMo high-entropy alloy in acidic oxidizing and neutral chloride solutions

Corrosion behavior of a dual-phase FeNiCrCuAl high entropy alloy in supercritical water

Corrosion behavior of Al12Cr12Fe35Mn21Ni20 high entropy alloy in different acidic media

Effect of Mo on microstructure, mechanical and corrosion properties of FeCrNiMnMox high-entropy alloys

Effect of Co, Ni, Cu content on phase composition, microstructure and corrosion resistance of Co1-xCrFeNi1+xCuy series high-entropy alloys

Microstructure and Corrosion Properties of Crmnfeconi High Entropy Alloy Coating