Abstract:Abstract In this paper, the new energy automobile front-end frame of a factory is taken as the research object, the polypropylene plastic is used to replace the traditional sheet metal material, and the hyper mesh is used to load the front-end frame's six loading loads, which are the locking limit tension and the cushion impact force, respectively, pedestrian impact strength, condenser support strength, radiator support strength, oil cooler support strength, ensure to achieve certain mechanical properties before production. The maximum warpage deformation is 1.023 mm by mold flow analysis with Moldflow. It does not meet the needs of manufacturers, so it is necessary to optimize the process parameters. We use the mold temperature, melt temperature, holding pressure, injection time, and holding time as test factors, and take the amount of warpage as the optimization goal. Then this paper uses the orthogonal test method to design the test plan and establishes 25 groups of 5-level 5-factor orthogonal tests. Moreover, the effect of the deformation on the warpage is analyzed. These are all to obtain the minimum warpage deformation and find the optimal combination of process parameters. Verification by numerical simulation shows that the warpage is reduced to 0.632 mm. By analyzing the range and variance, the combination of process parameters is optimized, and the warpage is effectively reduced. In the premise of satisfying mechanical properties, plastic instead of steel, to achieve a lightweight design. It provides correct theoretical guidance for setting the actual injection molding process parameters.

Study on flexible deformation of waste plastic film by fictitious particle method

Analysis Methods of Structural Design and Characteristics of Numerical Algorithm for ETFE Air Inflated Film Structures

Improved Computational Method Based Upon Slip-line Field Theory For Passive Plies For Practical Use

ELASTIC-PLASTIC ANALYSIS OF 3D SOLIDS USING THE FINITE PARTICLE METHOD

A rotational plastic potential model and non-associated plastic flow rule

Elastic/plastic Impact Simulation of Water Jet Using Smoothed Particle Hydrodynamics and Finite Element Method

3D Simulation of Filling Stage of Plastic Injection Molding Based on Improved Finite Volume Method

Investigation of Rigid Particle Flow Method in Simulating Free Forging Processes

Numerical Study of Thickness Distribution of Stretch-Blow Bottles for Defects Prediction

Research Plastic Plate Formation Process Based on Numerical Simulation

Release of Additives from Agricultural Plastic Films in Water: Experiment and Modeling.

Towards better predicting the settling velocity of film - shaped microplastics based on experiment and simulation data

Fast prediction of crystallinity in injection molding during the packing stage

Numerical study of wet plastic particle separation using a coupled DEM-SPH method

SIMULATION OF STEADY STATE SLAB EDGING WITH 3D RIGID-PLASTIC FEM

Finite element analysis of plastic recycling machine designed for production of thin filament coil

Research on Lightweight Injection Molding (CAE) and Numerical Simulation Calculate of New Energy Vehicle

Plastic wrinkling prediction in thin-walled part forming process: A review

Exploring flotation separation of polycarbonate from multi-microplastic mixtures via experiment and numerical simulation

Modelling and characterising FFF process of semi-crystalline polymers: Warpage formation and mechanism analysis

Mechanical Properties of Recycling Mixed Waste Plastic Predicted on Pallet Application Using Finite Element Analysis