Abstract:2219Al alloys microalloyed with varying Cd contents were processed by casting technique. Differential scanning calorimetry (DSC) was performed from 323 to 823 K at four different heating rates of 283, 289, 293 and 298 K min−1, to investigate the precipitation kinetics of the alloys. The heating cycle of DSC curves exhibited an endothermic peak in the intermediate temperature range from 603 to 713 K corresponding to the precipitation reaction, whereas an endothermic drift at elevated temperatures representing melting of the alloy phases. All the peak temperatures increased with an increase in heating rate, indicating the precipitation reaction to be kinetically controlled. A new methodology was proposed to model the kinetic rate equation, governing the endothermic precipitation peaks. Activation energy and related kinetic parameters were evaluated for the alloys, and the influence of Cd additions was investigated. Activation energy was observed to decrease by around 8.3%, due to microalloying with 0.06 mass% of Cd, thus kinetically favouring the precipitation reaction. Functional forms of mole fraction transformed were optimized, so that the present model of rate equation may achieve a proper fit with the experimental results of the corresponding reaction peaks. The transformation rate predicted from the rate equation and the estimated kinetic parameters, was successfully compared with the experimental data with fairly good accuracy. Such correlation with the experimental results validates the adapted analytical procedure, establishes the confidence and prediction capability of the present kinetic model and the accuracy of the kinetic parameters evaluated. X-ray diffraction (XRD) studies were resorted on the age-hardened alloys, to identify the possible precipitating phase(s). XRD patterns indicated the precipitation of θ-phase (CuAl2) within the Al matrix, which controlled the strengthening mechanism. The DSC and XRD results were further supported with the microstructural characterization of morphology and composition of different phases, as observed under SEM and EDS analysis. Trace contents of Cd exhibited to have significant potential to control the precipitation kinetics, activation energy, precipitating phases and respective microstructural evolution of the investigated 2219Al alloy system, during age-hardening treatment.

Determination of the precipitation kinetics of Ni3Al in the Ni–Al system using differential scanning calorimetry

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Effect of Substrate Characteristics on Interdiffusion Coefficients of Ni and Al Atoms in Β-Nial Phase of Aluminide Coatings

Atomic-scale computer simulation of mixture precipitation mechanism for Ni75AlxV25-x alloy

Early Stages of Precipitation in Γ' Phase of a Ni–Al–Ti Model Alloy: Phase-Field and First-Principles Study

Coarsening Kinetics of γ′ Precipitates in Dendritic Regions of a Ni3Al Base Alloy

Experimental study and thermodynamic modeling of the Al-Co-Cr-Ni system

Precipitation Sequence of Middle Al Concentration Alloy Using the Inversion Algorithm and Microscopic Phase Field Model

Composition and Temperature Dependence of Kinetic Behavior of Γ′ Precipitation in Ni–Al–Cr–Mo Quaternary Model Superalloys: A Phase Field Study

A Correlative Four-Dimensional Study of Phase Separation at the Subnanoscale to Nanoscale of a Ni-Al Alloy

Effects of solute concentrations on kinetic pathways in Ni-Al-Cr alloys

Mesoscopic quantitative chemical analyses using STEM-EDX in current and next generation polycrystalline Ni-based superalloys

Effect of Cooling Rate on Precipitation Behavior of Gamma Prime in a Newly Developed Co-based Superalloy

Modelling precipitation kinetics and investigating age-hardening behaviour of 2219Al alloys microalloyed with Cd

Thermodynamic Simulation Calculation on Precipitation Behavior of Equilibrium Phases in a Low Re bearing Nickel based Single Crystal Superalloy

An Investigation of High-Temperature Precipitation in Powder-Metallurgy, Gamma/Gamma-Prime Nickel-Base Superalloys

Determination of γ/γ' interface free energy for solid state precipitation in Ni-Al alloys from molecular dynamics simulation

Nanocalorimetry of Nanoscaled Ni/Al Multilayer Films: On the Methodology to Determine Reaction Kinetics for Highly Reactive Films

Non-isothermal kinetic parameters and models of crystallization for amorphous Fe-Co-Nb-Cu-B alloys

Precipitation of Ni3Al in a nickel rich NiAl

Precipitation of the Gamma Prime Phase in a Ni-co-based Superalloy During Different Stages of Cooling