BIOMECHANICAL INVESTIGATION OF COMBINED EFFECTS OF DISC DEGENERATION ANDOSTEOPOROSIS IN LUMBAR SPINE

F. Wagner,F. Amirouche,R. Varadarajan,K. Guppy

Abstract:INTRODUCTION Disc degeneration leads to many spinal disorders like stenosis spondylolisthesis, and osteophyte formation. Prevoius studies stipulate that osteoporosis leads to compression fracture of the vertebral body and causes spinal instability. Biomechanical investigation of stress changes in the lumbar vertebrae and intervertebral disc caused by disc degeneration has been performed using mathematical models and cadavaric studies [1]. Osteoporosis has also been studied following same mathematical and experimental procedures [2]. However, very little is known of the combined effects of osteoporosis and disc degeneration in the lumbar spine and how it may affect the treatment planning. This paper presents our findings on the sensitivity of stresses in annulus ground substance, endplate and pedicle, and the stiffness of motion segment to both disc degeneration and osteoporosis under flexion, extension, lateral bending and torsional moments using detailed validated finite element model of human L4-L5 motion segment. METHODS Six 3D Finite Element models of L4 L5 FSU were developed. They are as follows 1. Intact disc with normal Bone 2. Intact disc with osteoporotic bone 3. Stage (I) degenerated disc with normal bone 4. Stage (I) degenerated disc with osteoporotic bone 5. Stage (II) degenerated disc with normal bone 6. Stage (II) degenerated disc with osteoporotic bone These finite element models were analyzed using ANSYSv5.7. Geometric data of the vertebral body, facet joint and intervertebral disc were based on recent studies [3][4]. Cortical bone, cancellous bone, annulus ground substance and posterior elements were modeled as 3D Isoparametric 8 node hexahedral elements. The intervertebral disc was modeled similar to recent studies [5]. Facet contact was modeled as 3D point-to-point contact elements. All ligaments were modeled as tension only spar element and all material properties are based on recent studies [5]. The model was validated with experimental studies [6]. Stage (I) Disc degeneration (Dehydrated nucleus) was simulated by using stiffer solid elements for the nucleus with Young’s modulus twice that of annulus ground substance. Stage (II) Disc degeneration was simulated by doubling the young’s modulus of annulus ground substance and reducing the annulus fiber volume by 25% [7] and including stage (I) changes. Stage (II) Disc degeneration. This severe stage of degeneration was represented by a 25% reduction in disc height along with stage I and stage II changes. Osteoporosis of the vertebral body was simulated by reducing the young’s modulus of cancellous bone by 30%.

Medicine,Engineering