Abstract:Nowadays, every single distribution system needs to install an appropriate relay to keep the system safe. The operational and commonly recommended relay for distribution systems is the overcurrent (OC) relay. Throughout the distribution system, the protective relay is one of the methods that can detect and protect the location according to its observation from any fault from abnormal activity. Note that time coordination between the protective equipment relay needs to be a minimum of time interruption to prevent faults occurs. The ideal setting for all coordination protection relays is necessary to protect the device against electrical failure and interference. This paper analyzes the real results data collected for the selected commercial building of an OC relay implemented in a distribution board for high voltage and low voltage downward at a commercial building. All the parameters need to be clarified first before testing has been made and measurement is carried out using the MICROTEST 860 set. Based on the analysis, it proves that according to the IEC Standard of 0.10-time multiplier Setting (TMS) is practical to be used to obtain the operation time in seconds for the current curve set. Other than that, the results show that the normal inverse curve from manual calculation results is more accurate compared to the service setting (SS) made based on the incoming setting in a real commercial building. The case study for OC relay setting is related between current injection and time-tripping, which complies with the IEC 60255-3 standard using its formula. This method was applied to determine the characteristics of the curve. Hence, this research successfully determined the proper methods for the OC relay setting for the power distribution system. Besides, the feasibility and efficiency of OC relay data transmission are tested and checked successfully to implement the measurement method in the relay coordination study.

Design of Over/Under Voltage Protection Relay using Arduino Uno for FREEDM System

Design and Implementation of Multifunction Relay Based on Microcontroller

Design and Development of Overcurrent Protection Relay Inverse Definite Minimum Time Type Based on Arduino Uno

Design and Implementation of Overcurrent Protection Relay

Design and Phase Regulation Method of an Inverter System for Protection Relay Testing

Modelling and Implementation of Microprocessor Based Numerical Relay for Protection Against Over/Under Current, Over/Under Voltage

Design of Power Supply for Relay Testing Instrument Based on Micro-computer

Design of IoT based protection system for Distribution Breakers using Arduino

Design and Construction of Thermal Overload Relay (Siemens 3ua50) Based on Arduino Uno

Distribution Transformer Protection and Automatic System Using PLC

Relay Protection Design Scheme of 220 Kv Substation for Application of IEC 61850

Study of Reliability Modeling for Relay Protection System in Digital Substations

Design and Implementation of an Automatic Synchronizing and Protection Relay through Power-Hardware-in-the-Loop (PHIL) Simulation

On-Load Automatic Voltage Regulation System Designed Via Thyristor for Distribution Transformer

Design of Intelligent Protection Module for Low-voltage Power Distribution System

Design And Test Of Unified Power Flow Controller Protection Circuits

Protection Relay Setting based on Overcurrent Phenomena in Commercial Building

A novel digital protection scheme for microgrid

Adaptive electronic relay for smart grid based on self-healing protection

Software Design and Realization of Digital Relay Based on ARM Microcontroller

Enhancing resilience of advanced power protection systems in smart grids against cyber–physical threats