Abstract:A prototype STM system with high aspect ratio measurement capability is developed to fulfill accurate profile measurement of a high step microstructure with 90 degrees steep sidewall. Distinguished from the traditional STM, the new system consists of a long range piezoelectric (PZT) actuator with full stroke of 60 mu m as Z-direction servo scanner, a specially customized high aspect ratio STM probe with effective tip length of 300 mu m, and an X-Y motorized driven stage for planar scanning. A tilt stage is used to adjust the probe-sample relative angle to compensate the evitable non-parallel effects. Based on the new STM system, sample-tilt-scanning methodology is proposed for eliminating the scanning blind region between the probe and the microstructure. A high step microstructure with height of 23 mu m, 90 degrees steep sidewall and width of 50 mu m has been successfully measured. The slope angle of the sidewall has been achieved to be 85 degrees and the step height at the rising edge and the trench depth at the falling edge are both measured to be 22.96 mu m. The whole measuring process only spent less than 10 min. It provides an effective and nondestructive solution for the measurement of high step or deep trench microstructures. In addition, this work also opens the way for further study on sidewall roughness and the tip-sample interaction at the edge of the sidewall, which are highly valuable for fabrication and quality control of high step microstructures. (C) 2012 American Institute of Physics. [doi:10.1063/1.3676651]

Picometer-Sensitivity Surface Profile Measurement Using Swept-Source Phase Microscopy

High-Sensitivity Quantitative Phase Microcopy

High-sensitivity Quantitative Phase Microcopy (conference Presentation)

Surface wave illumination Fourier ptychographic microscopy.

Laser scanning saturated structured illumination microscopy based on phase modulation

Single-Shot White-Light Dispersive Interferometric Profilometer

Fast Surface Measurement Using Wavelength Scanning Interferometry with Compensation of Environmental Noise

Surface Profile Measurement of Micro-Optics by Using a Long Stroke Atomic Force Microscope

Label-free Surface-Sensitive Photonic Microscopy with High Spatial Resolution Using Azimuthal Rotation Illumination

Two-Dimensional Structural Surface Measurement Based On Spectrally Resolved White-Light Interferometry

Study and Numerical Simulation of a Surface Plasmon Resonance Sensor Using Bi-Beam Differential Measurement Approach

Exact surface measurement based on phase error insensitive method for white-light scanning interferometer

Extended Range Phase-Sensitive Swept Source Interferometer for Real-Time Dimensional Metrology

Note: Symmetric Modulation Methodology Applied In Improving The Performance Of Scanning Tunneling Microscopy

High-sensitive Quantitative Phase Imaging with Averaged Spectral Domain Phase Microscopy

Profile Measurements of Micro-Aspheric Surfaces Using an Air-Bearing Stylus with A Microprobe

Rapid Measurement Of A High Step Microstructure With 90 Degrees Steep Sidewall

Amplified Phase Measurement of Thin-Film Thickness by Swept-Source Spectral Interferometry

Sensitivity enhancement of surface plasmon resonance imaging sensor with structural parameter optimization based on polarization contrast modulation

A Phase-Shifted Surface Plasmon Resonance Sensor for Simultaneous Photoacoustic Volumetric Imaging and Spectroscopic Analysis

Small-angle Measurement Based on Surface-Plasmon Resonance and the Use of Magneto-Optical Modulation.