Abstract:Background Ceramic bearing surfaces have been introduced to prevent osteolysis after total hip arthroplasty (THA), but little is known about the difference in clinical and radiological results between pure alumina and sandwich alumina bearings. The purpose of this study was to analyze the results obtained with third-generation alumina-on-alumina THA with two different designs both in liner and femoral stem fixation after a minimum follow-up of 4.2 years.Methods The results of 195 primary alumina-on-alumina THAs in 167 patients were evaluated. The procedures were performed between January 1998 and October 2006. Three patients died and 11 patients were lost to follow-up, leaving a total of 153 patients (181 hips) available for study. In the 88 group A patients, 107 hips were implanted using pure alumina bearings with cementless femoral stems. These patients were followed for (6.84 +/- 1.49) years. In the 65 group B patients, 74 hips were implanted using sandwich alumina ceramic bearings with cemented femoral stems. These patients had a follow-up period of (7.73 +/- 1.60) years. Patients in both groups were evaluated clinically and radiographically.Results One ceramic liner fracture occurred in group A and five took place in group B (P <0.05), four of them revised for liner fracture. In each group, one acetabular shell migration happened without liner breakage and two hips developed deep infections, and all these six hips received revisions. Nine femoral components loosened in group B, with seven undergoing revisions. Kaplan-Meier survivorship at 5 years for revision of any component for any reason in group A was 96.26% compared to 90.54% in group B (P <0.05). Better function was determined in group A (average Harris hip scores: 92.13 +/- 2.85) than in group B (average Harris hip scores: 86.03 +/- 4.21) and the difference was significant (P <0.05). Squeaking was not recorded in either group.Conclusions The sandwich design of the acetabular bearings can not reduce the migration rate in ceramic bearings but increase the liner fracture rate compared to pure ceramic liners. The high loosening rate in fluted and taped designed cemented stems with sandwich liners warrant caution to their use. Chin Med J 2012;125(2):244-248

Comparison of femoral bone remodeling after total hip arthroplasty with cementless short-tapered wedge stem and fully hydroxyapatite-coated stem

Contact states with femoral cortical bone and periprosthetic bone mineral density changes differ between traditional and newly introduced fully hydroxyapatite-coated stems

Cementless Porous Tantalum Monoblock Tibia Vs Cemented Modular Tibia in Primary Total Knee Arthroplasty: A Meta-Analysis

Femoral Component Revision Using Extensively Porous-Coated Cementless Stem.

Comparison of Early Postoperative Stress Distribution around Short and Tapered Wedge Stems in Femurs with Different Femoral Marrow Cavity Geometries Using Finite Element Analysis

Comparison of Bone Remodeling Between Collum Femoris-Preserving Stems and Ribbed Stems in 1-Stage Bilateral Total Hip Arthroplasty.

Pure Alumina Bearings with Cementless Stems Versus Sandwich Bearings with Cemented Stems in Total Hip Arthroplasty.

Theoretical analysis of changes in femoral stresses after total hip arthroplasty]

A Comparison of Clinical Outcomes of a Straight and an Anatomical Uncemented Stem

Middle-term outcome and complications after primary total hip arthroplasty using a contemporary titanium tapered wedge cementless femoral stem

Comparison of mid-term clinical and radiological results of short and conventional femoral stems in total hip arthroplasty

The Biomechanical Study of Intertrochanic Fractures Treated with Cemented Femoral Stem

Adjustment of stem anteversion using tapered cone stem in total hip arthroplasty

Finite element analysis of changes in femoral stresses after elite total hip arthroplasty]

Finite Element Analysis of Femoral Stress Changes after Total Hip Arthroplasty

Use of Cementless Acetabular Component and Cemented Femoral Component in Total Hip Arthroplasty

The assessment of canal flare index and proximal femoral bone density can improve stem selection for peri-prosthetic bone maintenance after total hip arthroplasty

A Comparative Long-Term Registry Evaluation

No differences in clinical and radiographic outcomes between standard offset and high offset short cementless stems

Effects of porous tantalum on periprosthetic bone remodeling around metaphyseal filling femoral stem: a multicenter, prospective, randomized controlled study

Evaluation of Proximal Femoral Bone Mineral Density in Cementless Total Hip Arthroplasty: A 3-Arm Prospective Randomized Controlled Trial