Theoretical Study of Dy3+,Na+: PbGa2S4 Mid-Infrared Laser Based on Experimental Parameters
Xue-Zhou Yu,Chang-Bao Huang,Hai-Xin Wu,Qian-Qian Hu,Guo-Jin Liu,Ya Li,Zhi-Cheng Zhu,Hua-Bei Qi,You-Bao Ni,Zhen-You Wang
DOI: https://doi.org/10.7498/aps.73.20240223
IF: 0.906
2024-01-01
Acta Physica Sinica
Abstract:According to the absorption spectra of Dy3+, 3+ , Na+: + : PbGa2S4 2 S 4 crystal elements, as well as the theoretical calculations obtained from Judd-Ofelt analysis, we derive partial fluorescence absorption and emission cross sections. For energy levels that cannot be directly measured, we employ the reciprocal method to calculate their respective absorption cross-section and emission cross-section. Combing the experimental measurements and the calculation results, the experimental setup, which can generate a 4.3-mu m mid-infrared laser through directly pumping dysprosium and Dy3+, 3+ , Na+: + : PbGa2S4 2 S 4 crystals by 1.3 mu m and 1.7 mu m diode lasers, is investigated through numerical simulation. The spatial distributions of laser power, gain coefficient, and absorption coefficient within the crystal are obtained through numerical calculation. Furthermore, the effects of pumping power, crystal length, and output mirror reflectance on laser performance are analyzed. In this model, a 2.9-mu m laser oscillation is introduced in the optical path and the changes of output power before and after introduction are observed. Our results demonstrate that the introduction of 2.9-mu m laser oscillation effectively facilitates the particle number transfer from the 6H13/2 H 13/2 level to the ground state 6H15/2, H 15/2 , thereby reducing the self-terminating phenomenon during the transition between the 6H11/2 H 11/2 and 6H13/2 H 13/2 levels, and enhancing both output power and slope efficiency of the laser system. Numerical results indicate that maximum power output for the 1.3 mu m diode laser pumping is achieved at 103 mW with a pumping threshold of 12 mW and a slope efficiency of 2.8%, while for the 1.7-mu m diode laser pumping, the power output reaches up to 315 mW with a pumping threshold of 46 mW and a slope efficiency of 8%. Additionally, the calculation results show that the optimal crystal length is 17 mm for the 1.3 mu m diode laser pumping, and 32 mm for the 1.7 mu m diode laser pumping. Finally, the best reflectance value for the output mirror is 0.92. These numerical results are of great significance for guiding the crystal processing and the selection of optical path structure parameters.