Abstract:It has been a growing trend to use cold-formed steel (CFS) sections as primary structural members in low to multi-story buildings due to their high strength-to-weight ratios, ease of construction and flexibility in manufacturing to a variety of cross-sectional shapes. However, CFS frames are not widely used in seismic regions; one important reason is that the less redundant CFS joints generally have low ductility and energy dissipation capacity due to their inherently thin-walled properties. To address this issue, this paper presents an experimental programme and the corresponding results on two types of beam-to-column CFS joints, which are assembled to the two adjacent surfaces of the built-up CFS column in this paper. Different from the previous research, the two types of joints proposed are potentially suitable to connect CFS members in T-, L- and cruciform joints for multi-story framed-structure buildings. It was observed from the tests that the beams buckled before the occurrence of obvious damage to the tested joints. The two types of joints satisfied the seismic design philosophy of ‘strong connection-weak beam’. Joint Type 2 (JT2) exhibits overall higher performance in terms of strength, ductility, and energy dissipation capacity than the Joint Type 1 (JT1). JT1 satisfies the rotational requirement for Ordinary Moment Frames (OMFs) while JT2 satisfies the rotational requirement for Special Moment Frames (SMFs), as defined in AISC Seismic Provisions. The connection zones within both joints can be classified as semi-rigid according to the approach recommended by Eurocode 3: Part 1–8, with JT1 exhibiting higher stiffness than JT2. Overall, the proposed two joints connected with very slender beams and less bolts, have so far shown moderate performance to provide resistance and ductility to be applied in CFS framed buildings in seismic regions, which can be improved in further work.

Bolt-free post-tensioned connection for steel-framed modular buildings and design for optimal preloading

Tensile Behavior of Novel Column-to-column Connection for Modular Steel Construction Using High-Strength Bolts

Bolted End Plate Connections for Steel Reinforced Concrete Composite Structures

Seismic Behavior of Exterior Connections with Steel Beams Bolted to Cft Columns

Experimental and Numerical Study on the Performance of New Prefabricated Connections for Free-Form Grid Structures

Improved Seismic Design Using Bolted End Plate Connections For Steel Reinforced Concrete Composite Structures

Experimental analysis of the truss-to-column connection in a modularized prefabricated steel structure

Finite Element Analysis of Proposed Self-Locking Joint for Modular Steel Structures

Static And Seismic Experiments And Analysis Models Of Blind Bolted End Plate Joints To Cft Columns

Experimental study on seismic performance of column-column-beam joint in panelised steel-modular structure

Experimental and numerical studies of a new prefabricated steel frame joint without field-welding: Design and static performance

Development of new types of bolted joints for cold-formed steel moment frame buildings

Experimental study of end-plate connections between box-section columns and Ⅰ-section beams

Prefabricated Connection for Steel Beam and Concrete-Filled Steel Tube Column

Seismic performance of H-section beam to HSS column connection in prefabricated structures

Lateral resistance of multi-story modular buildings using tenon-connected inter-module connections

Experimental study on bolted-cover plate corner connections for column-supported modular steel buildings

Experimental study of a new beam-to-column connection for precast concrete frames under reversal cyclic loading

Novel coupled modular steel structure and seismic tests on high-performance interconnection

Experimental study on seismic performance of modular steel construction beam-to-beam combined side column joint with blind bolted connection

Structural Performance Evaluation of Modular Connections Using Developed Blocks