Abstract:The growing interest in sustainable buildings has inspired the improvement of timber structures in the construction market. As a raw material, wood may present natural defects that can cause changes in its mechanical properties, such as strength reduction, as well as brittle failure under tension, which limit the application of this material in construction. In recent decades, synthetic fibers with high tensile strength are available as construction material, and research to evaluate the efficiency of synthetic fibers and adhesive composites as a reinforcement for glued-laminated timber beams has been carried out. This paper deals with an experimental study applying bending tests to glue-laminated timber beams made of Pinus Elliottii, a low-strength wood class originated from reforestation, and strengthened with fiber reinforced polymers of Vectran fibers and epoxy adhesive. A numerical procedure based on the finite element method is also developed to compare with experimental results. Vectran is a synthetic thermoplastic fiber with high mechanical properties, however, its potential application as reinforcement material in structural pieces is still poorly explored. The results obtained in this work demonstrated that the application of Vectran-FRP reinforcement to glued-laminated timber beams provided both an increase of 19.48 to 34.95% in elastic regime stiffness and of 7 to 40% in ultimate load, when compared with unreinforced similar beams. Numerical analysis adequately confirmed the experimental results on elastic behavior, while in the non-elastic phase it revealed a considerable difference. A reduction in the rupture coefficient of variation regarding the reinforced beams was also verified. In addition, the application of fibers as structural reinforcement changed the timbeŕs failure mode from brittle in tension to ductile in compression. The results show that Vectran fibers are mechanically efficient as reinforcement, with perspectives of application in construction.

Bending performance of domestic larch cross-laminated timber reinforced with fiber-reinforced polymer

The Flexural Behavior of Cross Laminated Bamboo and Timber (CLBT) and Cross Laminated Timber (CLT) Beams

Evaluation of the bending performance of glued CLT-concrete composite floors based on the CFRP reinforcement ratio

Bending Performance of Nail-Laminated Bamboo-Timber Panels Made with Glubam and Fast-Grown Plantation Chinese Fir

Pull-Out Behavior of CFRP Bars in Glued-In Glubam Joints

Thermal Performance of Cross-Laminated Timber (CLT) and Cross-Laminated Bamboo and Timber (CLBT) Panels

Prestressed Glulam Beams Reinforced with CFRP Bars

Influence of densification on structural performance and failure mode of cross-laminated timber under bending load

Bending and Shear Performance of a Cross-Laminated Composite Consisting of Flattened Bamboo Board and Chinese Fir Lumber

Translaminar enveloping ply for CFRP interlaminar toughening

Flexural Behavior of Frp and Steel Reinforced Glulam Beams: Experimental and Theoretical Evaluation

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Strengthening of Full-Scale Laminated Veneer Lumber Beams with CFRP Sheets

Characterizing engineering performance of bamboo-wood composite cross-laminated timber made from bamboo mat-curtain panel and hem-fir lumber

Research on Lateral Resistance Performance of Prestressed Cross-Laminated Timber–Concrete Composite Structures under Reciprocating Loads

Gluing Techniques on Bond Performance and Mechanical Properties of Cross-Laminated Timber (CLT) Made from Larix kaempferi

Out-of-plane cross-angle bending stiffness of cross-laminated timber

Strengthening of Bent LVL Beams with Near-Surface Mounted (NSM) FRP Reinforcement

A Pilot Study on Cross-Laminated Bamboo and Timber Beams

Experimental investigation of glued-laminated timber beams with Vectran-FRP reinforcement

Experimental investigation of the shear force capacity of prismatic cross laminated timber beams