Abstract:The launch and recovery (L&R) of a small vessel from a large mothership occurs in various settings, such as the rescue of stranded personnel, extraction of unmanned autonomous sea monitoring sensors and the deployment of rescue submersibles. L&R of a small vessel, from a large mothership, at high sea states is difficult and is often avoided for safety reasons. This paper proposes sliding mode controllers to automate the process involving a modified davit crane in which the suspension point is movable. This is the first time a robust control strategy has been used to tackle this specific maritime problem. In this work, a second-order sliding mode controller is used to change the length of the cable during the recovery process and ensures that a pre-defined profile for the cable's length is followed. This controller alone proves to be sufficient for a safe recovery at low sea states. However, for higher sea states, the small vessel and mothership collide under certain circumstances. An integral sliding mode controller is introduced to adjust the crane's boom, which modifies the position of the suspension point, such that the oscillations of the small vessel are minimized. This controller aims to keep the distance between the mothership's hull and the centre of the small vessel at a constant value by adjusting the position of the crane's boom and reducing the swing angle. The overall control algorithm is found to be very effective, compared to the fixed boom case, ensuring that collisions do not occur under any of the tested configurations, and a safe distance is maintained between the mothership and the small vessel. The performance evaluation of the controller predicts that it will safely operate in rough sea states for any initial combination of swing angle and velocity, if a safe recovery can be carried out at a lower sea state for the same initial conditions.

Research on motion control of the semi-submersible platform under the mooring line failure

Mooring line failure diagnosis and motion control of semi-submersible platform based on the predictive model

Control Strategy for Performing Predictions for a Semi-Active Compensation System

Study on Global Performances and Mooring-Induced Damping of A Semi-Submersible

Effect of Failure Mode of Taut Mooring System on the Dynamic Response of A Semi-Submersible Platform

Influence of Active Control Strategy on the Motion Compensation at the Truncated Point of Mooring Line

Hierarchical NMPC–ISMC of active heave motion compensation system for TMS–ROV recovery

Sliding Mode Control for Underwater Multi-DoF Hydraulic Manipulator

Research on a Ship Mooring Motion Suppression Method Based on an Intelligent Active Anti-Roll Platform

Synchronize the Parafoil and the Vessel: A Hierarchical Distributed Nonlinear Model Predictive Control Approach

Sliding Mode Control Strategy of 3-UPS/S Shipborne Stable Platform with LSTM Neural Network Prediction

Control of the launch and recovery of small boats to a mothership in high sea states using sliding mode methods

Motion tracking control of actuator in the active-truncated model test of deep-water mooring system

Motion mitigation of hinged floating structures by adaptive control

Catenary Mooring Length Control for Motion Mitigation of Semi-Submersible Floating Wind Turbines

Impact of Thruster Failure on Mooring-assisted Dynamic Positioning System

Neural Network-Based Adaptive Antiswing Control of an Underactuated Ship-Mounted Crane With Roll Motions and Input Dead Zones

Short-term Motion Prediction of a Semi-Submersible Platform Based on a Combined Prediction Model

ROV recovery with wave-motion compensation using model predictive control

Dynamic responses and mooring line failure analysis of the fully submersible platform for floating wind turbine under typhoon

Adaptive Neural Network-Based Tracking Control of Underactuated Offshore Ship-to-Ship Crane Systems Subject to Unknown Wave Motions Disturbances