Abstract:The main goal of the work was to use rheological methods for assessing the properties of a composition based on polyether ether ketone (PEEK) to determine the concentration limits of the polymer in the composition and select the optimal content of this composition for powder molding. The rheological properties of highly filled suspensions based on PEEK and paraffin, as well as in paraffin-polyethylene mixtures at various component ratios, were studied. These materials are designed for powder injection molding and 3D printing. Suspensions with a PEEK powder content above 50% are not capable of flow and, with increasing pressure, slide along the surface of the channel. For compositions with a higher content (60 and 70 vol.%) PEEK, independence of the storage modulus from frequency is observed, which is typical for solids and confirms the assignment of such suspensions to elastic-plastic media. The introduction of high-density polyethylene into the composition helps improve the technological properties of suspensions, expanding the range of fluidity, although it leads to an increase in viscosity. In suspensions with a mixed composition of the liquid phase, with increasing temperature, a decrease in the storage modulus is observed at 120 °C and, on the contrary, an increase at 180 °C. The latter may be a consequence of the evaporation of paraffin and the softening of PEEK due to the approach to the glass transition temperature of the polymer. Suspensions with 40% PEEK content have an optimal set of rheological properties for powder injection molding. A 3D printing filament was also obtained from a composition with 40% PEEK, which had good technological properties for FDM 3D printing. Products of satisfactory quality from suspensions with 50% PEEK can be produced by powder injection molding, but not by 3D printing. The selected compositions were used to obtain real PEEK products for practical applications.

Simulation of Extrusion of High-Viscosity Pastes by a Piston Dosing Mechanism

Effect of Rheology and Cooling on Paste Extrusion Using Texture Analysis

Linking particle properties to paste extrusion flow characteristics using discrete element simulations

Computational Study of Extrusion Bioprinting with Jammed Gelatin Microgel-Based Composite Ink

Quantitative Dispensing Model and Experimental Study of High Viscosity Multi-Component Adhesive

Phase segregation lubricates paste extrusion

Effect of Particle Size and Shape on Wall Slip of Highly Filled Powder Feedstocks for Material Extrusion and Powder Injection Molding

Ceremics Paste Screw Extrusion and the Extruder Design Principle

The Rheology of Polyether Ether Ketone Concentrated Suspensions for Powder Molding and 3D Printing

Rheological characterization of pastes of alumina-toughened zirconia with additions of carbon nanofibers and evaluation of their printability via material extrusion

Effect of Starch on Extrusion Behaviour of Ceramic Pastes

Modeling and simulation for varying die gap fluid extrusion

Simulation of Coating -Visco-Elastic liquid in the Mico-Nip of Metering Size Press

Investigation of Rheological Behavior of Low Pressure Injection Molded Stainless Steel Feedstocks

A rheology model on extrusion flow of ceramic powder paste

A Study of Concentrated Suspensions in Polyethylene Melts and the Impact on Viscosity and Polymer Processing Operations

How rheological properties affect fine-line screen printing of pastes: a combined rheological and high-speed video imaging study

Tubing Extrusion of a Fluoropolymer Melt

Three dimensional simulation of viscoelastic polymer melts flow in a cast film process

Experiments and Discrete Element Simulation of the Dosing of Cohesive Powders in a Simplified Geometry

Fabrication of 3D Printed Metal Structures by Use of High-Viscosity Cu Paste and a Screw Extruder