Abstract:Ni atom is seen as a momentous impurity to extend the exciting response of TiO2 to the visible light and increase that photocatalytic reactivity. The impact of substituted nickel impurities in rutile (110) surface on the electronic structure, the formation energy of the oxygen vacancy defect, charge transfer and the energy of water adsorption in molecular and dissociated forms were successfully calculated by a full potential method based on density functional theory (DFT). Here, the pure, defective, Ni-doped and defective Ni-doped rutile TiO2 (110) surfaces were simulated. The analysis of partial DOS calculations of all surfaces showed that oxygen 2p and Ti 3d orbitals dominate the main contribution of the edge of the valence band maximum and the conduction band minimum respectively. By developing oxygen vacancy, the occupied defect states of 3d states of the nearest Ti atoms is pinned inside the conduction band. The nickel impurities create empty defect states appearing inside the band gap, one which is exactly above the valence band and the other in the middle, near the conduction band. The simultaneous effect of nickel impurity and O-vacancy is two occupied and one empty defect states inside the gap mainly corresponding to the Ni 3d orbitals. Ni impurity significantly not only reduces O-vacancy formation energy increases the water adsorption energy, especially in dissociated form. While the molecular adsorption is more favorable on the pure perfect rutile (110) surface, the dissociated form is preferred upon developing O-vacancy and Ni impurity. Both O-vacancy and Ni impurity expand the adsorption energy releasing a positive synergic effect on the reactivity of the rutile surface.

Effect of Point Defects on Water Adsorption on the ThO 2 {111} Surface: a First-principles Computational Study

Influence of subsurface defects on the surface reactivity of TiO 2: Water on anatase (101)

Theoretical Study of Native Point Defects on Anatase TiO 2 (101) Surface

Reactivity Of The Defective Rutile Tio2 (110) Surfaces With Two Bridging-Oxygen Vacancies: Water Molecule As A Probe

The adsorption of H2O on TiO2 and SnO2(110) studied by first-principles calculations

Influence of Excess Charge on Water Adsorption on the BiVO4(010) Surface

Ab Initio Study of Water Adsorption on Tio2-Terminated (100) Surface of Srtio3 with and Without Cr Doping

DFT Study of Methanol Adsorption on Defect-Free CeO2 Low-Index Surfaces

Two-photon Photoemission Spectroscopy of TiO2(110) Surfaces Modified by Defects and O2 or H2O Adsorbates

Role of oxygen vacancy in the adsorption and dissociation of the water molecule on the surfaces of pure and Ni-doped rutile (110): a periodic full-potential DFT study

Theoretical investigation of high coverage water adsorption on Co and Ni doped γ-Al2O3 surface

Structure and reactivity of a water-covered anatase TiO<sub>2</sub>(001) surface

Slab Model Studies of Water Adsorption and Decomposition on Clean and X- (X = C, N and O) Contaminated Pd(111) Surfaces

A computational study on the effect of Ni impurity and O-vacancy on the adsorption and dissociation of water molecules on the surface of anatase (101)

Coverage-dependent adsorption and dissociation of H2O on Al surfaces

First-principles study of water adsorption and dissociation on the UO 2 (111), (110) and (100) surfaces

Density Functional Theory Study on the Adsorption and Decomposition of H2O on Clean and Oxygen-Modified Pd (1 0 0) Surface

Water Adsorption on A Co(0001) Surface

The Roles of Reduced Ti Cations and Oxygen Vacancies in Water Adsorption and Dissociation on Srtio3(110)

Theoretical study of water adsorption and dissociation on Ta3N5(100) surfaces.

First-principles study of water adsorption and dissociation on the UO2 (1 1 1), (1 1 0) and (1 0 0) surfaces