A compact 16-module camera using 64-pixel CsI(Tl)/Si p-i-n photodiode imaging modules
W.-S. Choong,G. J. Gruber,W. W. Moses,S. E. Derenzo,S. E. Holland,M. Pedrali-Noy,B. Krieger,E. Mandelli,G. Meddeler,N. W. Wang,E. K. Witt,G.J. Gruber,W.W. Moses,S.E. Derenzo,S.E. Holland,N.W. Wang,E.K. Witt
DOI: https://doi.org/10.1109/tns.2002.803676
IF: 1.703
2002-10-01
IEEE Transactions on Nuclear Science
Abstract:We present a compact, configurable scintillation camera employing a maximum of 16 individual 64-pixel imaging modules resulting in a 1024-pixel camera covering an area of 9.6 cm×9.6 cm. The 64-pixel imaging module consists of optically isolated 3 mm×3 mm×5 mm CsI(Tl) crystals coupled to a custom array of Si p-i-n photodiodes read out by a custom integrated circuit (IC). Each imaging module plugs into a readout motherboard that controls the modules and interfaces with a data acquisition card inside a computer. For a given event, the motherboard employs a custom winner-take-all IC to identify the module with the largest analog output and to enable the output address bits of the corresponding module's readout IC. These address bits identify the “winner” pixel within the “winner” module. The peak of the largest analog signal is found and held using a peak detect circuit, after which it is acquired by an analog-to-digital converter on the data acquisition card. The camera is currently operated with four imaging modules in order to characterize its performance. At room temperature, the camera demonstrates an average energy resolution of 13.4% full-width at half-maximum (FWHM) for the 140-keV emissions of 99m Tc. The system spatial resolution is measured using a capillary tube with an inner diameter of 0.7 mm and located 10 cm from the face of the collimator. Images of the line source in air exhibit average system spatial resolutions of 8.7- and 11.2-mm FWHM when using an all-purpose and high-sensitivity parallel hexagonal holes collimator, respectively. These values do not change significantly when an acrylic scattering block is placed between the line source and the camera.
engineering, electrical & electronic,nuclear science & technology