Abstract:A low-cost 1-DOF hand exoskeleton for neuromuscular rehabilitation has been designed and assembled. It consists of a base equipped with a servo motor, an index finger part, and a thumb part, connected through three gears. The index part has a tri-axial load cell and an attached ring to measure the finger force. An admittance control scheme was designed to provide intuitive control and positive force amplification to assist the user's finger movement. To evaluate the effects of different control parameters on neuromuscular re-sponse of the fingers, we created an integrated exoskeleton-hand musculo-skeletal model to virtually simulate and optimize the control loop. The exo-skeleton is controlled by a proportional derivative controller that computes the motor torque to follow a desired joint angle of the index part, which is obtained from inverse kinematics of a virtual end-effector mass driven by the finger force. We conducted parametric simulations of the exoskeleton in action, driven by the user's closing and opening finger motion, with different proportional gains, end-effector masses, and other coefficients. We com-pared the interaction forces between the index finger and the ring in both passive and active modes. The best performing assistive controller can re-duce the force from around 1.45N (in passive mode) to only around 0.52N, more than 64% of reduction. As a result, the muscle activations of the flex-ors and extensors were reduced significantly. We also noted the admittance control scheme is versatile and can also provide resistance (e.g. for strength training) by simply increasing the virtual end-effect mass.

Synthesis of a single-degree-of-freedom noncircular pulley-five-bar finger rehabilitation mechanism considering force transfer performance

Optimal Design of a Bilateral Stand-Alone Robotic Motion-Assisted Finger Exoskeleton for Home Rehabilitation

A five-bar mechanism to assist finger flexion-extension movement: system implementation

A Novel Robotic Exoskeleton for Finger Rehabilitation: Kinematics Analysis

Mechanism Design and Performance Analysis of a Wearable Hand Rehabilitation Robot

Research on Mechanical Design of a Multi-Function Finger Rehabilitation Robot

Self-reconfiguration Method of an Intelligent Multi-mode Linkage Finger Based on Quantitative Reconstruction of Center Point

A Remotely Driven Finger Rehabilitation Robot for Passive and Active Rehabilitation

Kinematics and dynamics of a tendon-driven prosthetic finger

Finger Exoskeleton for Rehabilitation of Finger Extension and Flexion by Multi-Segment Mechanism

Mechanical Design and Analysis of the End-Effector Finger Rehabilitation Robot (EFRR) for Stroke Patients

Design and Optimization of a Custom-Made Six-Bar Exoskeleton for Pulp Pinch Grasp Rehabilitation in Stroke Patients

Design of a Multi-Mode Mechanical Finger Based on Linkage and Tendon Fusion Transmission

Design of an Underactuated Finger Based on a Novel Nine-Bar Mechanism

Development and evaluation of a hand exoskeleton for finger rehabilitation*

Design of A Hand Exoskeleton Rehabilitation Device

Design and Driving Performance Study of Soft Actuators for Hand Rehabilitation Training

Fusing Topology Optimization and Pseudo-Rigid-Body Method for the Development of a Finger Exoskeleton

Evaluation of a 1-DOF Hand Exoskeleton for Neuromuscular Rehabilitation

Optimization of the Rotational Asymmetric Parallel Mechanism for Hip Rehabilitation With Force Transmission Factors

A Design of Hand Rehabilitation Exoskeleton Mechanism Adapted to Different Finger Lengths.