Abstract:Plastic wastes are environmentally problematic and costly to treat, but they also represent a vast untapped resource for the renewable chemical and fuel production. Pyrolysis has received extensive attention in the treatment of plastic wastes because of its technical maturity. A sole polymer in the waste plastic is easy to recycle by any means of physical or chemical techniques. However, the majority of plastic in life are mixtures and they are hard to separate, which make pyrolysis of plastic complicated compared with pure plastic because of its difference in physical/chemical properties. This work focuses on the synergistic effect and its impact on chlorine removal from the pyrolysis of chlorinated plastic mixtures. The pyrolysis behavior of plastic mixtures was investigated in terms of thermogravimetric analysis, and the corresponding kinetics were analyzed according to the distributed activation energy model (DAEM). The results show that the synergistic effect existed in the pyrolysis of a plastic mixture of LLDPE, PP, and PVC, and the DAEM could well predict the kinetics behavior. The decomposition of LLDPE/PP mixtures occurred earlier than that of calculated ones. However, the synergistic effect weakened with the increase of LLDPE in the mixtures. As for the chlorine removal, the LLDPE and PP hindered the chlorine removal from PVC during the plastic mixture pyrolysis. A noticeable negative effect on dechlorination was observed after the introduction of LLDPE or PP. Besides, the chlorine-releasing temperature became higher during the pyrolysis of plastic mixtures ([LLDPE/PVC (1:1), PP/PVC (1:1), and LLDPE/PP/PVC (1:1:1)]. These results imply that the treatment of chlorinated plastic wastes was more difficult than that of PVC in thermal conversion. In other words, more attention should be paid to both the high-temperature chlorine corrosion and high-efficient chlorine removal in practical. These data are helpful for the treatment and thermal utilization of the yearly increased plastic wastes.

Low chlorine oil production through fast pyrolysis of mixed plastics combined with hydrothermal dechlorination pretreatment

Separate two-step and continuous two-stage pyrolysis of a waste plastic mixture to produce a chlorine-depleted oil

Pyrolysis of mixed plastic waste (DKR-350): Effect of washing pre-treatment and fate of chlorine

Understanding the Dechlorination of Chlorinated Hydrocarbons in the Pyrolysis of Mixed Plastics

Efficient Treatment of Oily Sludge Via Fast Microwave-Assisted Pyrolysis, Followed by Thermal Plasma Vitrification.

Synergistic Effect and Chlorine-Release Behaviors During Co-pyrolysis of LLDPE, PP, and PVC

Production of clean oil with low levels of chlorine and olefins in a continuous two-stage pyrolysis of a mixture of waste low-density polyethylene and polyvinyl chloride

Oil recovery from microwave co-pyrolysis of polystyrene and polypropylene plastic particles for pollution mitigation

Co-pyrolysis of Oil Sludge with Hydrogen-Rich Plastics in a Vertical Stirring Reactor: Kinetic Analysis, Emissions, and Products

Hydrothermal dechlorination strategy for high-quality oil recovery from polyvinyl chloride

Investigation on thermal dechlorination and catalytic pyrolysis in a continuous process for liquid fuel recovery from mixed plastic wastes

Production of low molecular oil from typical polyolefin plastics through molten salts thermal treatment

Study on Pyrolysis Characteristics and Kinetics of Mixed Plastic Waste

Pyrolysis of Polyvinyl Chloride (PVC)-Containing Mixed Plastic Wastes for Recovery of Hydrocarbons

Chemical Recycling of Mixed Polyolefin Post-Consumer Plastic Waste Sorting Residues (MPO323)—Auto-Catalytic Reforming and Decontamination with Pyrolysis Char as an Active Material

Catalytic stepwise pyrolysis for dechlorination and chemical recycling of PVC-containing mixed plastic wastes: Influence of temperature, heating rate, and catalyst

Enhancement of fuel-grade oil yields from thermal pyrolysis of polyethylene and polystyrene through reflux condenser assisted autoclave reactor

Investigation on Co-Hydropyrolysis of Heavy Bio-Oil with Degradable Plastics

Co-pyrolysis of pinewood and HDPE: pyrolysis characteristics and kinetic behaviors study

Experimental investigation of products from thermal treatment of real-world mixed single-use and multi-layered waste plastics