Abstract:Ultrasonic flowmeters (UFMs) based on the principle of transit time difference are widely used in process industries. The transit time difference is obtained through analyzing received acoustic signals generated by a couple of transducers located upstream and downstream respectively. The quality of received acoustic signal will directly affect the measurement accuracy of UFM. For this reason, a measurement-calculation coupled approach combining measurement tools and numerical simulation for calculating the acoustic signal of UFM is proposed in this paper. The method can predict the acoustic signals of UFM with different flowrates. First, important boundary condition (vibration velocity on transmitter transducer surface) is measured by measurement tool, which can reduce computational complexity and also avoid modeling transmitter transducers. Second, simulating the wave propagation (difficult to access experimentally) within moving medium by using the measured vibration velocity. Third, obtaining the transfer function of receiver by comparing estimated force acting on the receiver transducer surface with measured voltage signal from receiver, which can avoid modeling receiver transducer. Finally, predicting the received acoustic signal at different flowrates by using the transfer function. The rationality of predicted data was validated by comparing experimental and predicted acoustic signal on receiver transducer at different flowrates. A good agreement between simulated and experimental data was obtained, which means that the working processes of the acoustic signal generated by actual transducers inside UFMs can be accurately predicted based on this method. Analysis of the predicted results will provide good guides and advices to the design of UFMs involving actual application.

Ultrasonic density measurement cell design and simulation of non-ideal effects

Void Fraction Measurement Of Gas-Liquid Two-Phase Flow Based On (Cd)-D-4 Technique

Ultrasonic Technique for Density Measurement of Liquids in Extreme Conditions

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Numerical Analysis of Transducer Installation Effect on Ultrasonic Gas Flow Meter

High Precision Ultrasonic Testing Method for Density of Engineering Plastics

A Trapezoidal Cantilever Density Sensor Based on MEMS Technology

Simultaneously Measuring Thickness, Density, Velocity and Attenuation of Thin Layers Using V(z,t) Data from Time-Resolved Acoustic Microscopy.

A Method Combining Measurement Tool and Numerical Simulation for Calculating Acoustic Signals of Ultrasonic Flowmeter

Temperature Compensation In Fluid Density Measurement Using Micro-Electromechanical Resonant Sensor

Simultaneous Measurement of Elastic Moduli, Attenuation, Density, and Thickness of a Layer by Ultrasonic Spectroscopy Using Point-Focus Transducer

Density Measurement Sensitivity of Micro-Cantilevers Influenced by Shape Dimensions and Operation Modes

Viscosity Measuring Cell Using Ultrasonic Wave Mode Conversion

MEMS fluid density sensor based on oscillating piezoresistive microcantilever

Study on Tuning Fork Liquid Density Sensor

Equivalent Circuit Analysis of CMUTs-based Device for Measurement in Liquid Samples

Numerical Modeling for Analyzing Microfluidic Acoustophoretic Motion of Cells and Particles with Application to Identification of Vibro-Acoustic Properties

In-situ Density Measurement for Plastic Injection Molding Via Ultrasonic Technology

High precision UTDR measurements by sonic velocity compensation with reference transducer

FEM modeling and simulation of broadband ultrasonic transducers with randomized inhomogeneous backing material

Density, ultrasound velocity, acoustic impedance, reflection and absorption coefficient determination of liquids via multiple reflection method