Compensation control for roadheader's pitch and yaw position pose deviation based on cutting boom motion

Zhang Deyi,Liu Songyong,Li Shihang,Liang Hao,Zhu Qixin,Niu Xuemei

DOI: https://doi.org/10.1016/j.tust.2024.105839

IF: 6.9

2024-05-29

Tunnelling and Underground Space Technology

Abstract:Roadheader is the core equipment of roadway excavation. Affected by the sudden change of cutting load and complex roadway floor conditions, the position pose of the roadheader is very prone to deviation. Usually, the roadheader's position pose deviation is corrected by controlling its supporting and tracking unit. However, this will greatly reduce the roadway excavation efficiency in case of a small position pose deviation. Therefore, a new scheme for the automatic compensation of position pose deviation is proposed by controlling the cutting boom motion. Firstly, the kinematics model of cutting boom is established, and the pitch and yaw position pose deviation compensation models are constructed. To improve the control accuracy of cutting boom motion, the reduced-order active disturbance rejection controller is designed. Then, the compensation control experiments of pitch and yaw position pose deviation are carried out based on the position pose compensation experiment system. The results show that the maximum errors of cutting trajectory after compensation meet the requirements of roadway cross-section quality, proving the effectiveness of the proposed position pose compensation control scheme.

construction & building technology,engineering, civil