Abstract:High-energy ball milling represents an efficient process for producing composite powders consisting of ceramic particles dispersed in a metallic matrix. However, collision events, plastic deformations, and cold welding during the milling lead to a flake or block-like shape of the resulting composite powders. Further consolidation of such irregularly shaped powders by powder bed-based additive manufacturing technologies can be challenging because of their low flowability and low bulk density. In this work, different approaches, including milling process parameters (speed, process control agent atmosphere) and post-treatments (mechanical and thermal), are investigated on their suitability to influence the particle shape, especially concerning the roundness of the composite powders consisting of the aluminum alloy AlSi10Mg with 5 vol% SiC and Al2O3 reinforcement. It is found that milling with menthol as a process control agent leads to the finest composite powder compared to other milling parameters, with the lowest particle roundness of 0.39 (initial powders 0.84). No success in rounding the milled composite powder could be achieved through mechanical post-treatment in a planetary ball mill. On the other side, the thermal spraying of, e.g., SiC reinforced AlSi10Mg powder resulted in a 77–82% relative roundness. A remarkable change in the microstructure and the shape of the composite powders could also be observed after heat treatment in tube furnaces at a temperature above the melting point of AlSi10Mg. The best result in terms of improved roundness (relative to around 85%) was obtained for Al2O3 reinforced at 600 °C. A further increase of the temperature to 700 °C resulted in a moderate coarsening of powders with Al2O3 and extensive sintering of powders with SiC, presumably due to a different distribution inside the matrix.

Effect of Milling Variables on Particle Deformation in a Stirred Media Mill

Experimental Study and Numerical Simulation of the Influence of Ball Milling on Mechanical and Physical Properties of Matcha Powder

Effect of grinding media on the milling efficiency of a ball mill

Influencing the Size and Shape of High-Energy Ball Milled Particle Reinforced Aluminum Alloy Powder

Silicon Powder Properties Produced in a Planetary Ball Mill as a Function of Grinding Time, Grinding Bead Size and Rotational Speed

Effect of ball size and powder loading on the milling efficiency of a laboratory-scale wet ball mill

Influence of Media Geometry on Wet Grinding of a Planetary Ball Mill

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

The effects of processing parameters on the shape of particle size distribution and grinding rate in a stirred mill

Dry grinding in planetary ball mills: Evaluation of a stressing model

Analysis Of Alumina Particles Size And Shape Formation From Developed Planetary Ball Mill

Powder Ball Milling: An energy balance approach to particle size reduction

Effect of grinding media properties and stirrer tip speed on the grinding efficiency of a stirred mill

Effect of Ball Size on the Microstructure and Morphology of Mg Powders Processed by High-Energy Ball Milling

Effect of operating conditions on the particle size distribution and specific energy input of fine grinding in a stirred mill: Modeling cumulative undersize distribution

The influence of suspension properties on the grinding behavior of alumina particles in the submicron size range in stirred media mills

Optimization of the high energy ball-milling: Modeling and parametric study

Effects of Ball Size Distribution and Mill Speed and Their Interactions on Ball Milling Using DEM

Influence of processing parameters on grinding mechanism in planetary mill by employing discrete element method

The influence of the weighted average diameter of the ball on the particle size of the final product

Characterization of Stressing Conditions in a High Energy Ball Mill by Discrete Element Simulations