Abstract:Deep coals are generally in a high geothermal environment, and when UCG (underground coal gasification) is carried out, the long-term high temperature effect will cause different degrees of thermal stress damage to coals and rocks, which will change the original stress balance inside coals and rocks, and bring potential threats to safe and efficient mining. For this reason, taking the deep coal with impact tendency as the research object, the experiments on uniaxial compression and AE (acoustic emission) characteristics of the deep coal with impact tendency after high temperature are carried out, and the internal relationship between the overall deformation characteristics and AE characteristics of coal samples are described. The interaction mechanism of energy accumulation, dissipation and release in different stages of coal and its correlation with temperature are analyzed. The test results show that the higher the temperature, the greater the thermal stress damage, and the more obvious the deterioration of compressive strength of coal samples. When in a high temperature environment (≥ 300 °C), the coal samples have almost no compaction stage, the plastic deformation increases rapidly, and the failure mode transitions from brittle failure to "tough-brittle" failure. The AE energy reaches the maximum at 100 °C, and decreases linearly with the increase of temperature; the elastic modulus of coal is greatly affected by temperature, at 400 °C, compared with intact coal samples, the decrease rate is 62.17%; the peak strain of coal samples decreases continuously with the increase of temperature, but the average strain rate increases continuously; the energy accumulation and release are closely related to temperature, with the increase of temperature, the energy storage capacity of coal samples decreases gradually, and the percentage of dissipated energy increases significantly, and the kinetic energy of coal samples is small when they are destroyed, and the destruction speed is relatively slow; the energy conversion of coal samples can be divided into the initial energy accumulation stage I, the accelerated energy accumulation stage II and the rapid energy dissipated stage III; the percentage of elastic energy in the three stages before the destruction of coal samples went through the process of low–high-low, while the dissipated energy is the opposite, and the dissipated energy increased significantly before the destruction, indicating that the coal samples entered the accelerated destruction stage.

Experimental study on the dynamic direct tensile fracture mechanism of thermally damaged sandstone

Direct tensile mechanical properties and damage fracture mechanisms of thermally damaged coal measures sandstone under high strain rate loading

Impact Dynamic Properties and Energy Evolution of Damaged Sandstone Based on Cyclic Loading Threshold

Experimental Study on Mechanical Characteristics and Fracture Patterns of Unfrozen/Freezing Saturated Coal and Sandstone

Mechanical behavior and fracture characteristics of high-temperature sandstone under true triaxial loading conditions

Microstructural and Thermal Properties of Coal Measure Sandstone Subjected to High Temperatures

Study on the mechanical behavior and rupture characteristics of coal after thermal damage

The Evolution of Sandstone Microstructure and Mechanical Properties with Thermal Damage

Constitutive Model and Fracture Failure of Sandstone Damage under High Temperature-Cyclic Stress

Experimental Investigation on Coal Deterioration Deformation Mechanism and Energy Evolution Law after High Temperature Pre-damage

Research on dynamic cracking properties of cracked rock mass under the effect of thermal treatment

Physical and Mechanical Properties and Damage Mechanism of Sandstone at High Temperatures

Experimental investigation of a fissured rock with thermal storage potential subjected to descending amplitude low cycle impacts

Study on dynamic fracture properties of sandstone under the effect of high-temperature using large-scale sample

Experimental Study on the Damage Evolution Behavior of Coal Under Dynamic Brazilian Splitting Tests Based on the Split Hopkinson Pressure Bar and the Digital Image Correlation

Dynamic Tensile Strength and Failure Mechanisms of Thermally Treated Sandstone under Dry and Water-Saturated Conditions

Dynamic impact properties of deep sandstone under thermal-hydraulic-mechanical coupling loads

Study on Impact Damage and Energy Dissipation of Coal Rock Exposed to High Temperatures

The Effects of High Temperature on Crack Propagation and Failure Characteristics of Sandstone

Experimental investigation on the fracture surface features of heat-treated red sandstone containing fissure under constant amplitude low cycle impact using 3D digital reconstruction

Study of the mechanical characteristics of coal-serial sandstone after high temperature treatment under true triaxial loading