Abstract:3D printing technology is gradually considered to be a rapid development of a green revolution in the field of architecture. Recently, utilizing solid mine waste to replace natural sand not only greatly reduces the 3D printing costs, but also contributes to an environmental sustainability development. However, most solid waste inevitably has an impact on the inherent mechanical strength and printability of concrete materials. It is an urgent requirement to expand the alternative materials and improve the overall property of 3D concrete materials. This paper reported an innovative concrete material that replaced natural sand with fine limestone powders for 3D concrete printing applications. The experimental measurements were performed including microstructures characteristics, flowability, buildability, shrinkability, layer-interface properties, mechanical properties and interlayer bonding strength. Besides, an effective method was proposed to characterize the printable properties of concrete materials and then the reasonable limestone powder replacement ratio was determined. Based on the investigation results, appropriate substituting limestone powder (40%) can effectively improve the grading of the concrete, thus promoting its printability and buildability. Moreover, the microstructures of the 3D printing concrete materials after curing were denser and their mechanical property improved by approximately 45%. With the further increase of replacement ratio, the reduction in the flowability led to a decrease of the printability. A large number of fine particles increased the shrinkage of the curing process and some bubbles were stranded inside the materials due to its increase in the viscosity, thereby reducing the mechanical properties of the hardened material. The produced concrete for 3D printing can be treated as an eco-friendly building material that contributes to the rational development and resource utilization of solid water, thus promoting the sustainable development of construction field.

Freeze-thaw resistance of 3D-printed composites with desert sand

3D printed concrete with recycled sand: Pore structures and triaxial compression properties

3D printing concrete with recycled sand: The influence mechanism of extruded pore defects on constitutive relationship

Frost Resistance of Desert Sand Concrete

3D printing eco-friendly concrete containing under-utilised and waste solids as aggregates

Mechanism of the influence of multi-scale pore structure on the triaxial mechanical properties of 3D printed concrete with recycled sand

Turning Desert Sand into Building Material Products: an Ambitious Attempt of Solar 3D Printing

A new method to replicate high-porosity weak rocks subjected to cyclic freezing-thawing: Sand 3D printing and digital image correlation explorations

Utilization of solid mine waste in the building materials for 3D printing

Effect of Processing on the Air Void System of 3D Printed Concrete

Study of 3D printed concrete with low-carbon cementitious materials based on its rheological properties and mechanical performances

Mechanical properties and acoustic emission analysis of desert sand concrete reinforced with steel fiber

Strength and Proportioning Design of 3D Printed Concrete (3DPC) Based on Aggregate Gradation Optimization

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

3D Printed Concrete: Fresh and Hardened Properties

Experimental investigation on the performance and mesostructure of multi-material composite 3D-printed sand mold

Sustainable ultra-high performance concrete with incorporating mineral admixtures: Workability, mechanical property and durability under freeze-thaw cycles

Influence of Aeolian Sand on Capillary Water Absorption of Concrete Under Freeze–Thaw Conditions

Research on the Preparation and Mechanical Properties of Solidified 3D Printed Concrete Materials

Plastic shrinkage and cracking of 3D printed mortar with recycled sand