Abstract:In lower-limb rehabilitation, there is a specific group of patients that can perform voluntary muscle contraction and visible limb movement provided that the weight of his/her leg is fully supported by a physical therapist. In addition, this therapist is necessary in guiding the patient to switch between hip-only and knee-only motions for training specific muscles effectively. These clinic needs have motivated us to devise a novel reconfigurable gravity-balanced mechanism for tackling with the clinical demands without the help from therapists. The proposed mechanism has two working configurations, each leading the patient to do either hip-only or knee-only exercise. Based on the principle of static balancing, two tensile springs are attached to the mechanism to eliminate the gravitational effect of the mechanism and its payload (i.e., the weight of the patient's leg) in both configurations. The gravity balancing design is verified by a numerical example and adams software simulation. A mechanical prototype of the design was built up and was tested on a healthy subject. By using electromyography (EMG), the myoelectric signals of two major muscles for the subject with/without wearing the device were measured and analyzed. The results show that the myoelectric voltages of the stimulated muscles in both hip-only and knee-only motion modes are reduced when the subject is wearing the device. In summary, the paper for the first time demonstrates the design philosophy and applications by integrating the reconfigurability and static balancing into mechanisms.

Redesign of a Balance Rehabilitation Device Based on a Parallel Continuum Mechanism

Conceptual design and dimensional synthesis of a novel parallel mechanism for lower-limb rehabilitation

Design Paradigm for Human Size Manipulator with High Payload, Repeatability, and Bandwidth

A Novel Reconfigurable Gravity Balancer for Lower-Limb Rehabilitation With Switchable Hip/Knee-Only Exercise

Reconfiguration of a parallel kinematic manipulator with 2T2R motions for avoiding singularities through minimizing actuator forces

Mechanism Design and Performance Analysis of a Wearable Hand Rehabilitation Robot

Conceptual design of a rehabilitation device based on cam-follower and crank-rocker mechanisms hand actioned

Serial–Parallel Mechanism and Controller Design of a Robotic Brace for Dynamic Trunk Support

A Modular, Tendon Driven Variable Stiffness Manipulator with Internal Routing for Improved Stability and Increased Payload Capacity

Continuum Manipulator with Redundant Backbones and Constrained Bending Curvature for Continuously Variable Stiffness.

Kinematics and Performance Analysis of a Parallel 4-UPS/RRR Trunk Rehabilitation Robot

Design and Performance Analysis of a Mecanum-Built Perturbation-Based Balance Training Device

Optimum design and preliminary experiments of a novel parallel end traction apparatus for upper-limb rehabilitation

Design of A Hand Exoskeleton Rehabilitation Device

Research on the configuration of a balanced disability rehabilitation robot based on redundant degrees of freedom

Design of a self-aligning 3-DOF actuated exoskeleton for diagnosis and training of wrist and forearm after stroke

Mechatronic Design, Experimental Setup and Control Architecture Design of a Novel 4 DoF Parallel Manipulator

Design, implementation, and control of a deformable manipulator robot based on a compliant spine

Design and Control of a Low-cost Non-backdrivable End-effector Upper Limb Rehabilitation Device

Design and Construction of a Prototype of an Assisting Device for Arm Exercise

Manipulability Optimization of a Rehabilitative Collaborative Robotic System