Abstract:Li-rich, manganese-based cathode materials are attractive candidates for Li-ion batteries because of their excellent capacity, but poor rate and cycle performance have limited their commercial applications. Herein, Li-rich, manganese-based cathode materials were modified with aluminum isopropoxide as an aluminum source modifier using a sol–gel technique followed by a wet chemical method. To investigate the structure, morphology, electronic state, and elemental composition of both pristine- and surface-modified Li1.2Ni0.13Co0.13Mn0.54O2, various characterizations were performed. Based on density functional theory simulations and the results of electrochemical tests, the surface of the modified cathode material was found to contain at least part of the LiAlO2 phase. This was attributed to the aluminum isopropoxide reacting with a Li2CO3/LiOH byproduct on the material surface to form LiAlO2 with a three-dimensional Li-ion channel structure. Electrochemical testing revealed that a 3 wt % aluminum isopropoxide coating of cathode materials exhibited excellent electrochemical performance. Furthermore, the initial Coulombic efficiency and discharge capacity at 0.1 C were up to 88.55% and 272.7 mAh g–1, respectively. A final discharge capacity of 186.4 mAh g–1 was achieved, corresponding to a capacity retention of 83.55% after 300 cycles at 0.5 C. This was attributed to LiAlO2 partially accelerating the diffusion of Li ions and Al2O3 aiding the avoidance of side reactions in the mixed coating layer by partially protecting the structure.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10459?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10459</a>.Rietveld refinement patterns, TEM and high-resolution TEM, average discharge potential, rate performance, cyclic voltammogram analyses, XPS analyses after 300 cycles at 0.5 C, interface structures, and oxygen vacancy formation enthalpy (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10459/suppl_file/am0c10459_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Design and tailoring of carbon-Al2O3 double coated nickel-based cation-disordered cathodes towards high-performance Li-ion batteries

Enhancing high-voltage performances of nickel-based cathode material via aluminum and progressive concentration gradient modification

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Towards Rational Design of High Performance Ni-rich Layered Oxide Cathodes: the Interplay of Borate-Doping and Excess Lithium

Excellent electrochemical properties of Ni-rich LiNi0.88Co0.09Al0.03O2 cathode materials co-modified with Mg-doping and LiBO2-coating for lithium ion battery

Low‐Electronegativity Cationic High‐Entropy Doping to Trigger Stable Anion Redox Activity for High‐Ni Co‐Free Layered Cathodes in Li‐Ion Batteries

Improving the Cycle Stability of LiNiO2 through Al3+ Doping and LiAlO2 Coating

Enhancing Thermal and High-Voltage Cycling Stability of Ni-Rich Layered Cathodes through a Ti-Doping-Induced Surface-Disordered Structure

Enhanced Li-ion Intercalation Kinetics and Lattice Oxygen Stability in Single-Crystalline Ni-rich Co-poor Layered Cathodes

Stabilizing Ni‐Rich LiNi 0.92 Co 0.06 Al 0.02 O 2 Cathodes by Boracic Polyanion and Tungsten Cation Co‐Doping for High‐Energy Lithium‐Ion Batteries

Enhanced electrochemical performance of Ni-rich cathode material by N-doped LiAlO2 surface modification for lithium-ion batteries

Carbon-coated cation-disordered rocksalt-type transition metal oxide composites for high energy Li-ion batteries

Enhanced Cathode Performance: Mixed Al 2 O 3 and LiAlO 2 Coating of Li 1.2 Ni 0.13 Co 0.13 Mn 0.54 O 2

Suppressing capacity fading and voltage decay of Ni-rich cathode material by dual-ion doping for lithium-ion batteries

Probing the Nature of Li+/Ni2+ Disorder on the Structure and Electrochemical Performance in Ni-Based Layered Oxide Cathodes

Boosting cationic and anionic redox activity of Li-rich layered oxide cathodes via Li/Ni disordered regulation

Surface Atomic Rearrangement with High Cation Ordering for Ultra-Stable Single-Crystal Ni-Rich Co-Less Cathode Materials

An integrated surface coating strategy to enhance the electrochemical performance of nickel-rich layered cathodes

Improving the Electrochemical Properties of Ni-based Cation-Disordered Cathode by Fe and F Co-Doping

Mechanochemically Robust LiCoO2 with Ultrahigh Capacity and Prolonged Cyclability