Abstract:The glass‐to‐mold adhesion in precision glass molding could severely degrade the quality of molded optics and shorten the lifespan of the precious molds. Since the consequences of adhesion take effect during the separation between glass and molds, it is important to investigate the debonding behaviors of a typical glass molding interface. To this end, here we perform a probe tack test procedure for borosilicate glass BK7, where debonding is conducted at molding temperature and specific velocity. We fully characterize the debonding behaviors by using the peak adhesion stress σmax and the work of debonding Wdeb. Experiments show that when temperature is decreased from 690 °C to 655 °C at 10 µm/s, σmax continuously increases, while Wdeb first increases but then sharply decreases. When the debonding velocity is increased from 10 µm/s to 50 µm/s at 680 °C, σmax also increases while Wdeb overall decreases. Therefore, the debonding behaviors are highly temperature and rate dependent. More importantly, depending on the debonding conditions, three debonding types are identified, i.e., the cohesive bulk deformation, the cohesive‐interfacial transition and the interfacial fracture. The cohesive type can be converted into the interfacial fracture, by either decreasing temperature or increasing the debonding velocity. Based on the Wdeb criterion, the three debonding regimes can be clearly distinguished. Finally, analyses on the temperature and velocity experimental results are unified by incorporating the reduced crack velocity ɑTνc. The dependences of both viscoelasticity and Wdeb on ɑTνc qualitatively explain the transition condition for different debonding types. Concerning these findings, the work of debonding not only supplements the characterization of adhesion strength, but also throws insightful light on revealing the debonding mechanisms.

Water Stress Corrosion in a Directly Bonded Borofloat Glass Interface

Dynamic condensation of water at crack tips in fused silica glass

Temperature and rate dependent debonding behaviors of precision glass molding interface

Stress-dependent Molecular Pathways of Silica–water Reaction

Unravelling Physical Origin of the Bauschinger Effect in Glassy Polymers

Crack arrest and stress dependence of laser-induced surface damage in fused-silica and borosilicate glass

Measure for optical robustness of directly bonded glass-to-glass joint using its interaction with damage induced by fs laser

Low-Temperature Bonding And Interfacial Failure Behavior Of Si/Glass And Glass/Glass Chips

Corrosion of ternary borosilicate glass in acidic solution studied in operando by fluid-cell Raman spectroscopy

Optimized Sealing Process And Real-Time Monitoring Of Glass-To-Metal Seal Structures

Coefficient of Thermal Expansion Mismatch Induced Stress Calculation for Field Assisted Bonding of Silicon to Glass

The Competing Effect of Initial Crack Depth Versus Chemical Strengthening Parameters on Apparent Fracture Toughness of Sodium Aluminosilicate Glass

Water and Carbon Dioxide Capillary Bridges in Nanoscale Slit Pores: Effects of Temperature, Pressure, and Salt Concentration on the Water Contact Angle

Experimental investigation on thermal healing of subsurface damage in borosilicate glass

Stress Corrosion Phenomenon of BeO at Room Temperature and Its Mechanism: Experimental and molecular dynamics study

Enhancing the design bending strength of new and aged glass with a functional coating

Formation and evolution of secondary phases and surface altered layers during borosilicate glass corrosion in pore water

Steam strengthened glass

Tungsten carbide molds for precision glass molding process: Mechanism of high-temperature degradation

Mechanical Stresses Estimation in Silicon and Glass Bonded at Elevated Temperature

The Study of the Bonding Energy on Silicon-to-Glass Wafer Bonding