Abstract:Expanding gain bandwidth into the L-band for erbium-doped fiber amplifiers (EDFAs) is a crucial strategy to overcome limitations in prevalent C-band focused commercial silica-based EDFAs, significantly boosting optical network transmission capacity. Herein, we synthesized Er3+-doped broadband near-infrared emission tellurite glasses utilizing the melt quenching process, systematically exploring the impact of ZnCl2 on the glass structure and optical properties. The 82TeO2–3Nb2O5–15ZnCl2–3Er2O3 (TNZ15) glass emerged as a standout candidate for broadband amplifiers around wavelength at 1.55 μm. With escalating ZnCl2 concentration, a discernible red shift in the emission peak wave lines was observed, accompanied by an expansion of the full width at half maximum (FWHM) from 98 nm to 106 nm. Noteworthy characteristics of all samples included exceptional thermal stability and elevated near-infrared (NIR) transmittance. Application of the Judd-Ofelt (J-O) theory facilitated the calculation of J-O parameter intensity, providing deeper insights into the optical behavior of the materials. Finally, the evaluation of TNZ15 planar optical waveguides, employing the vertical top pumping mode of two 980 nm LEDs, encompassed both the C-band (1530–1565 nm) and the L-band (1565–1625 nm). The results underscore the potential of TNZ15 glass as a promising gain material for broadband optical amplifiers and lasers, offering valuable insights into the development of next-generation optical amplification technologies.

Experimental insights into increasing laser output at 2.8?μm in Er^3+-doped zinc-tellurite fibers

Experimental insights into increasing laser output at 2.8 µm in Er3+-doped zinc-tellurite fibers

Low-Threshold Microlaser in Er : Yb Phosphate Glass Coated Microsphere

High-power continuous-wave mid-infrared 2.8 μm Er-doped fiber lasers: A review

High-power Lasing at 900 Nm in Nd3+-doped Fiber: a Direct Coordination Engineering Approach to Enhance Fluorescence

Er3+/Yb3+ Co-Doped Fluorotellurite Glass Fiber with Broadband Luminescence

Highly efficient actively Q-switched Er^3+-doped ZBLAN fiber laser operating around 2.8 μm using a La_3Ga_5SiO_14 electro-optical modulator

Pump quantum efficiency optimization of 3.5 μm Er-doped ZBLAN fiber laser for high-power operation

1.8?mJ pulses at 1560?nm based on a 55?μm core pure-erbium-doped VLMA fiber

Spectroscopy and LD end-pumped high power 2.79 μm CW laser from an Er:LuYSGG mixed crystal

Spectroscopic properties of new Yb 3+-doped TeO 2-ZnO-Nb 2O 5 based tellurite glasses with high emission cross-section

Toward an ultra-broadband emission source based on the bismuth and erbium co-doped optical fiber and a single 830nm laser diode pump.

Structure and Spectral Properties of Er3+-Doped Bismuth Telluride Near-Infrared Laser Glasses

Self-Q-switching behavior of erbium-doped tellurite microstructured fiber lasers

Direct coordination engineering manipulates fluorescence intensity inversion leading to ~ 900 nm high-power lasing in Nd3+-doped fiber

Visible-infrared optical performance of Er3+-doped fluorotellurite glass via hybrid structural fluctuations

Net gain in C+L band from LED pumped broadband emission in Er3+-doped oxyhalide tellurite glass

145 W single-frequency fiber laser at 1607 nm with the seed and MOPA configuration

14.1 W continuous-wave dual-end diode-pumped Er:Lu_2O_3 laser at 2.85 μm

Generation of 2.8 μm fiber laser using an Erbium‐doped ZBLAN double‐clad fiber in a linear‐cavity‐free space experimental setup

First Experimental Investigation of the Amplification of a Yb-doped Fiber Laser Pumped with 1000 and 1014-Nm Laser Diodes