Abstract:The smart diesel program requires the engine electronic control unit to consider additional parameters, such as altitude and climatic conditions, in the mapping calibration process. A specially designed environmental simulation cabin, which can simulate environmental conditions at any longitude and dimension, would allow dynamometer testing to be performed indoors. Considering its high cost, a three-dimensional (3D) computational fluid dynamics (CFD) is needed to guide and/or complement experimental researches. As a result, the main objective of this study was to establish a 3D RANS model (i.e., reasonable computational cost and running time) that can provide in-cylinder details and predict the efficiency of a 6V150 diesel engine under varied operating conditions. A sector mesh approach was employed, considering only the compression, combustion, and expansion periods from intake valve closing to exhaust valve opening. The results indicated that the model simulated cylinder pressure agreed well with the experimental data, with relative errors of less than 6% during the primary compression, combustion, and expansion. Further, the model predicted heat release phasing was inconsistent with the experimental results, with absolute errors of less than one crank angle degree for peak pressure location, CA50, and ignition delay. In addition, the multidimensional model captured the effects of environmental pressure and temperature on spray formation (i.e., the dominant phenomenological event). Moreover, the model reasonably reproduced the effects of engine control variables on performance and emissions. All these observations demonstrated the validity of the selection and calibration of geometry, chemistry, and submodels including turbulence, spray, heat transfer, combustion, etc. Overall, the model was deemed capable of predicting combustion characteristics under extreme conditions, including high-temperature, high-cold, and high-altitude environments, which can facilitate the development of smart engines.

A multi-time scales semi-decoupled CHT (Coupled Heat Transfer) model and its application on piston transient heat transfer simulation

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

Effect of Fire-Deck Thickness on Thermal Status of Cylinder Head

Study of Different Cooling Structures on the Thermal Status of an Internal Combustion Engine

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Simulation Study on Cyclic Transient Heat Transfer of Piston-cylinder Liner

An accelerated time-scale decomposition algorithm for transient thermal fluid-solid coupled simulations in multi-medium systems

Simulation of In-Cylinder Radiative Heat Transfer of Diesel Engine with Monte-Carlo Method

Multi-scale Thermal Analysis Approach for the Typical Heat Exchanger in Automotive Cooling Systems

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

Numerical and experimental study on piston multi-physical field heat load of marine engine based on high frequency oscillatory cooling and combustion characteristics

Study of In-Cylinder Heat Transfer Boundary Conditions for Diesel Engines under Variable Altitudes Based on the CHT Model

Research on Cylinder Head Thermal State Simulation

Analysis of thermal-mechanical coupling strength and fatigue life of cylinder head

An In-Cylinder Transient Heat Transfer Model for Temperature Field Simulation of Diesel Engine Structure

Partitioned Coupled Heat Transfer Fluid-Structure Interaction for Transient and Steady State Analysis of Aero Engines Applications

Multi-dimensional simulation of HCCI engine using parallel computation and chemical kinetics

THERMAL LOAD ANALYSIS AND CONTROL OF FOUR-STROKE HIGH SPEED DIESEL ENGINE

Studies on the Critical Heat Flux in Fuel Assembly Using a Modified Two-Phase Multi-Scale Interface Model-Validation and Sensitivity Analysis

Cfd -Based Modelling On Inter Facial Heat Transfer For Water Quenching

Coupled Fluid-Thermal-Solid Simulation of Axial Through-Flow Rotating Cavities