High-performance triboelectric nanogenerator with dual nanostructure for remote control of switching circuit

Yanhong Dong,Yange Feng,Daoai Wang
DOI: https://doi.org/10.1039/d4sc01432d
IF: 8.4
2024-05-29
Chemical Science
Abstract:Preparing nanostructured surfaces has been considered as an effective method to improve the output of triboelectric nanogenerator (TENG), while how to quickly prepare materials with nanostructured surface for TENG has always been a challenging target. Here, polypropylene nanowires and electrospun nylon 11 nanofibers were successfully prepared through a simple, time-saving and high-success-rate method. Compared with flat TENG, the output performance of dual nanostructured TENG is enhanced by more than 5 times. After 1H,1H,2H,2H-perfluorooctyl trichlorosilane assembling on the surface of the polypropylene film, the dual nanostructured TENG achieved the maximum output with the short-circuit current, output voltage, and charge density of 63.3 μA, 1135 V and 161.5 μC/m2, respectively. Compared with planar structured TENG, both short-circuit current and output voltage were enhanced by about 18 times, and the charge density was increased by about 36 times. In addition, the TENG showed good working stability with almost no output decrease after continuous operation of 193,000 cycles. The electricity generated by this TENG can successfully light up 1280 LEDs and continuously power a multi-functional electronic watch. Finally, the triboelectric signal generated by this TENG is used to control optocoupler switch, indicating good application prospects in remote control switching circuit.
chemistry, multidisciplinary
What problem does this paper attempt to address?