Abstract:Tanks and silos are often designed as ring-stiffened cylindrical shells. Nowadays, the load-increasing effect of closely spaced ring stiffeners under axial compression has received limited attention in research and practice. Considering the structural safety, the ring-stiffened shell needs to be estimated on the conservative side in practice. This is not desirable in terms of modern lightweight steel structures. However, material efficiency is achieved by combining thin plates with ring-stiffeners. In this paper, small specimen experimental series are carried out to calibrate numerical models, which are subsequently used in parameter studies, because the large-scale experiments are cost-intensive and therefore difficult to carry out in the laboratory. The small cylindrical shells are manufactured by welding of two half-cylindrical shells and the ring stiffeners are spot-welded to the cylindrical shell. Geometric dimension of shell specimens is measured by 3D scanning technology. The measured geometric imperfection information is directly imported into the numerical model based on a mapping relationship and the buckling tests are recalculated by means of geometrically and materially nonlinear analysis with imperfection. The results indicate that the buckling resistance calculated by the Finite Element analysis is very close to that of the test results. The initial geometric imperfection is discussed with reference to the Eurocodes design standard. Furthermore, influence of the ring-stiffener parameter, including imperfection amplitude, radius over thickness ratio, geometry of ring stiffener etc., on the buckling load and knockdown factor is discussed based on a large number of parameter study.

A note on structural mode transitions in buckling of radially stretched annular plates

In-Plane Nonlinear Buckling Analysis of Deep Circular Arches Incorporating Transverse Stresses

Buckling of Cylindrical Shells with Arbitrary Circumferential Thickness Variations under External Pressure

Numerical Study on Buckling Behaviors of Thin-Walled Longitudinal Corrugated Cylindrical Shells under Axial Compression Loads

Buckling of Simply Supported Thin Plate with Variable Thickness under Bi-Axial Compression Using Perturbation Technique

Static and dynamic interactive buckling of isotropic thin-walled closed columns with variable thickness

Dynamic Behavior and Buckling Analysis of Thin Rectangular Plate Rotating Around Its Symmetrical Axis

Buckling of ring-stiffened cylindrical shell under axial compression: Experiment and numerical simulation

Axisymmetric Postbuckling Analysis of Size-Dependent Functionally Graded Annular Microplates Using the Physical Neutral Plane

Local-global mode interaction in stringer-stiffened plates

Reduced order models for the buckling of hyperelastic beams

Buckling of Thin-Walled Cylinders from Three Dimensional Nonlinear Elasticity

Axisymmetric Post-Buckling of A Functionally Graded Circular Plate Subjected to Uniformly Distributed Radial Compression

Reduced model and nonlinear analysis of localized instabilities of residually stressed cylinders under axial stretch

Static and dynamic stability of variable thickness annular plates

Buckling instability of a thin-layer rectilinear Couette flow

Buckling analysis of thin-walled rectangular cantilever beam with elastic rotational constraint

Boundary layer theory for the buckling and postbuckling of an anisotropic laminated cylindrical shell. Part I: Prediction under axial compression

Local Buckling Analysis of Restrained Orthotropic Plates under Generic In-Plane Loading

Post-Buckling Analysis of a Rod Confined in a Cylindrical Tube

A non-linear rod model for folded elastic strips