Abstract:There is an urgent need to develop non-destructive testing (NDT) methods for infrastructure facilities and residences, etc., where human lives are at stake, to prevent collapse due to aging or natural disasters such as earthquakes before they occur. In such inspections, it is desirable to develop a remote, non-contact, non-destructive inspection method that can inspect cracks as small as 0.1 mm on the surface of a structure and damage inside and on the surface of the structure that cannot be seen by the human eye with high sensitivity, while ensuring the safety of the engineers inspecting the structure. Based on this perspective, we developed a radar module (absolute gain of the transmitting antenna: 13.5 dB; absolute gain of the receiving antenna: 14.5 dB) with very high directivity and minimal loss in the signal transmission path between the radar chip and the array antenna, using our previously developed technology. A single-input, multiple-output (SIMO) synthetic aperture radar (SAR) imaging system was developed using this module. As a result of various performance evaluations using this system, we were able to demonstrate that this system has a performance that fully satisfies the abovementioned indices. First, the SNR in millimeter-wave (MM-wave) imaging was improved by 5.4 dB compared to the previously constructed imaging system using the IWR1443BOOST EVM, even though the measured distance was 2.66 times longer. As a specific example of the results of measurements on infrastructure facilities, the system successfully observed cracks as small as 0.1 mm in concrete materials hidden under glass fiber-reinforced tape and black acrylic paint. In this case, measurements were also made from a distance of about 3 m to meet the remote observation requirements, but the radar module with its high-directivity and high-gain antenna proved to be more sensitive in detecting crack structures than measurements made from a distance of 780 mm. In order to estimate the penetration length of MM waves into concrete, an experiment was conducted to measure the penetration of MM waves through a thin concrete slab with a thickness of 3.7 mm. As a result, Λexp = 6.0 mm was obtained as the attenuation distance of MM waves in the concrete slab used. In addition, transmission measurement experiments using a composite material consisting of ceramic tiles and fireproof board, which is a component of a house, and experiments using composite plywood, which is used as a general housing construction material in Japan, succeeded in making perspective observations of defects in the internal structure, etc., which are invisible to the human eye.

Design Concept of a Low-Terahertz Imaging Radar

Radar-Centric Photonic Terahertz Integrated Sensing and Communication System Based on LFM-PSK Waveform

A 144GHz 0.76cm-resolution sub-carrier SAR phase radar for 3D imaging in 65nm CMOS.

A Terahertz Photonic Imaging Radar System Based on Inverse Synthetic Aperture Technique

High range resolution wideband terahertz FMCW radar with a large depth of field

The Feature Recognition of CFRP Subsurface Defects Using Low-Energy Chirp-Pulsed Radar Thermography

Comparative Analysis of Single- and Multiple-Frequency Thermal Wave Radar Imaging Inspection of Glass Fiber Reinforced Polymer (GFRP)

Terahertz Nondestructive Testing with Ultra-Wideband FMCW Radar

Optimization of Thermal-Wave Radar Thermography by Transverse Heat Flow Suppression Technique for Accurate Defect Detection of CFRP Laminates

Measurement Methodology: Terahertz Technique: A Non-Destructive Testing Method for Composite Defect Detection

Quantitative non-destructive evaluation of CFRP delamination defect using laser induced chirp-pulsed radar photothermal tomography

A Terahertz 3-D Imaging Method for Complex Internal Structure of Object

Real Aperture Continuous Terahertz Imaging System and Spectral Refinement Method

A Terahertz 3D Imaging Method for Complex Internal Structure of Object

Nondestructive Testing of Defects in Polymer–Matrix Composite Materials for Marine Applications Using Terahertz Waves

Augmented Reality Terahertz (AR-THz) Sensing and Imaging with Frequency-Modulated Continuous-Wave Radar

Rapid sensing of hidden objects and defects using a single-pixel diffractive terahertz sensor

Defect Detection of GFRP Composites through Long Pulse Thermography Using an Uncooled Microbolometer Infrared Camera

Nondestructive detection of CFRP subsurface defects using transient lock-in thermography

Miniaturized multi-modality field-ready sensing system for defect detection of CFRP materials

Development of a High-Sensitivity Millimeter-Wave Radar Imaging System for Non-Destructive Testing