Nanofiltration membrane with modified nano-gradient structure and positive charge for Li separation from high Mg/Li ratio brine

Peng Zhao,Fei Guo,Lingfeng Wang,Huange Zhen,Ning Zhang,Shaohua Yin,Guoli Zhou,Xuehua Ruan,Gaohong He,Xiaobin Jiang
DOI: https://doi.org/10.1016/j.desal.2024.117394
IF: 11.211
2024-02-01
Desalination
Abstract:Nanofiltration membranes with high selectivity and long-term stability for magnesium and lithium ions are crucial to efficiently enriching lithium resources in salt lake brines. Herein, a nano-gradient-structured nanofiltration membrane was fabricated, in which PEI with different molecular weights and TMC were utilized in a gradient interfacial polymerization process to construct the target active layer. Via this facile strategy, the grafting density of PEI and the amino group introduced were properly adjusted, and the pore size distribution and surface charge of the active layer were optimized. The fabricated active layer simultaneously possesses sub-nanometer pore size with a modified gradient structure and high interfacial positive charges, which can accurately screen lithium and magnesium. The successful grafting of secondary PEI and the high positive charge and continuity of the active layer have been demonstrated. After 150 hour operation (Mg/Li ratio of 50), PEI-70000/PA/PES nanofiltration membrane achieved a lithium‐magnesium separation factor (S Li/Mg ) as high as 150 while maintaining the stable permeation flux of approximately 20 L·m −2 ·h −1 ·MPa −1 , and the terminal Mg/Li ratio on the permeable side falls to 0.32, which exhibits significant potential for extracting Li from salt lake brines with high Mg/Li ratio with promising long-term stability.
engineering, chemical,water resources
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the efficient extraction of lithium resources from salt - lake brines with a high Mg/Li ratio. Specifically, the researchers construct a nanofiltration membrane with a nano - gradient structure and positive charge to improve the separation efficiency of magnesium ions (Mg\(^{2+}\)) and lithium ions (Li\(^+\)), while ensuring long - term stability. This is of great significance in practical applications because lithium is an important strategic resource and is widely used in industries such as lithium - ion batteries, electronic chips, ceramics, and glass. However, since the hydrated ion diameters of lithium and magnesium are very close, being 0.76 nm and 0.86 nm respectively, it is difficult to achieve efficient separation by the traditional sieving effect. Therefore, it is particularly urgent to develop a nanofiltration membrane technology that can accurately separate lithium and magnesium. The key points in the paper include: - **Nano - gradient structure**: By using polyethyleneimine (PEI) and trimethyl chloride (TMC) with different molecular weights, the target active layer is constructed during the gradient interfacial polymerization process, optimizing the pore size distribution and surface charge. - **Positive charge enhancement**: The secondary PEI is successfully introduced, and the positive charge density of the active layer is increased, thereby enhancing the repulsion of magnesium ions. - **Long - term stability**: After 150 hours of operation, the PEI - 70000/PA/PES nanofiltration membrane achieved a lithium - magnesium separation factor (S\(_{Li/Mg}\)) as high as 150 under the condition of an Mg/Li ratio of 50, while maintaining a stable permeation flux of about 20 L·m\(^{-2}\)·h\(^{-1}\)·MPa\(^{-1}\). These technological improvements enable the nanofiltration membrane to not only efficiently separate lithium and magnesium when treating salt - lake brines with a high Mg/Li ratio but also maintain long - term performance stability, showing great potential in practical applications.