Abstract:This paper defines a control method for shift torque exchange stage and a torque distribution control method for speed regulation stage. In the torque exchange stage, the torque distribution problem of active and passive clutches considers the injection of sine curve for local correction, which can solve the fish belly problem of hydraulic response (i.e. the hydraulic response is slow at the beginning and the hydraulic response is fast at the end). In the speed regulation stage, the target speed gradient profile is determined according to different shift types. The determination of the target speed gradient profile integrates different driving modes, throttle, P2 energy and clutch temperature. In the speed regulation stage, the torque distribution control problem of the speed phase including which actuator (P1, engine, C0 clutch) is used preferentially for speed regulation. a) If the speed regulation torque assigned to the input shaft exceeds the input shaft intervention torque capacity, then the excess part is assigned to the clutch for speed regulation. b) If the speed regulation torque assigned to the input shaft is less than the input shaft intervention torque capacity and the speed regulation torque assigned to the input shaft is less than the motor 2 speed regulation torque intervention capacity, the speed regulation torque is assigned preferentially to P2 for lifting torque. The total P2 request torque for P2 is equal to the sum of the speed regulation torque intervention of P2 and the P2 torque requested by ECM because of the fast response and high precision of the motor. c) If the governing torque assigned to the input shaft is less than the input shaft intervention torque capability and the governing torque assigned to the input shaft is greater than the motor 2 governing torque intervention capability, the excess is assigned to the engine. The total engine requested torque is equal to the sum of the engine governing torque intervention and the engine torque requested by the ECM.

A two-speed actuator for robotics with fast seamless gear shifting

A Fast Gear-Shifting Actuator for Robotic Tasks with Contacts

Leveraging Natural Load Dynamics with Variable Gear-ratio Actuators

A practical optimal control approach for two-speed actuators

Design of an Actuator for Biped Robots Based on the Axial Flux Motor.

Simulation and Validation of A Dual-motor Coupled Joint Actuator

A Dual-Motor Actuator for Ceiling Robots with High Force and High Speed Capabilities

High-performance transmission mechanism for robotic applications

Lightweight Electrohydrostatic Actuator Drive Solution for Exoskeleton Robots

Precise and coordinated gearshift control for AMT gearshift system equipped with two linear actuators

A Bimodal Hydrostatic Actuator for Robotic Legs with Compliant Fast Motion and High Lifting Force

New Intelligent Transmission Concept for Hybrid Mobile Robot Speed Control

The High-payload Manipulator Development Based on Novel Two-stage Cycloidal Speed Reducers and Hub Motors

The Cable-Driven Parallel-Helix-Actuator: Design, Modeling, and Simulation

Multimodal Hydrostatic Actuators for Wearable Robots: A Preliminary Assessment of Mass-Saving and Energy-Efficiency Opportunities

Acceleration Feedback Controlof a Harmonic Drive Parallel Robot.

Motor Control During Gearshift Phase to Reduce the Oscillation in Dual Hybrid Vehicles

Multi-Speed Transmission Mechanism Using a Compound Planetary Gear Set and Brakes

Single Actuator with Versatile Controllability of 2-DOF Assistance for Exosuits via a Novel Moving-Gear Mechanism

Research of a Novel 2-DOF Planar Parallel Robot System

Modeling and Analysis of Gear-Shifting Process of Motor-Transmission Coupled Drive System