Active and reactive power injection of energy storage for short-term frequency stability in islanded power systems

Umer Akram,Rakibuzzaman Shah,Nima Amjady,N. Mithulananthan,Syed Islam

DOI: https://doi.org/10.1016/j.est.2024.111914

IF: 9.4

2024-05-15

Journal of Energy Storage

Abstract:Fast frequency response (FFR) is crucial to enhance and maintain the frequency stability in power systems with high penetration of converter-interfaced renewable energy sources (RES). Active power based FFR reserves, such as energy storage systems (ESSs), are being considered for this purpose. However, the cost associated with ESS-based FFR reserves can be significantly high due to the high-power capacity associated with the FFR reserves. Therefore, this paper proposes a novel FFR reserve to achieve a techno-economically feasible solution, i.e., to achieve a better or similar service with a smaller size of ESS. Unlike the conventional FFR reserve that just uses active power, the proposed active and reactive power-based FFR reserve (i.e., P-Q-FFR reserve) modulates the grid's active and reactive powers. The challenges associated with the P-Q-FFR reserve design are the estimation of optimal values of MVAr, MW, and MWh to be injected into the system while ensuring the frequency and voltage stabilities at the lowest possible cost. First, a data-driven technique based on frequency dynamic signature (FDS) is developed in this work to identify the suitable location of the P-Q-FFR reserve. Afterward, a two-layered region reduction iterative algorithm (TL-RRIA) is developed to determine the storage size (MW, MWh, and MVAr) for the P-Q-FFR reserve. The proposed solution is tested using the DIgSILENT PowerFactory. Simulation results show the effectiveness of the proposed TL-RRIA and data-driven FDS technique. A techno-economic comparison between the conventional FFR reserve and proposed P-Q-FFR reserve is also presented to show the superiority of the proposed one.

energy & fuels