3D Finite Element Study of the Physiological Anchorage Control Concept on Anchorage Molars in Lingual Orthodontics
Jiayuan Zhao,Majing Su,Qian Zhao,Jiajie Liu,Junbin Wang,Junjie Wang,Xiaoli An
DOI: https://doi.org/10.1155/2022/1421586
2022-11-22
Abstract:Objective: To study the effect of the physiological anchorage control concept on anchorage molars in lingual and labial orthodontic techniques. Methods: Three-dimensional finite element models, including the right maxillary first molar, periodontal ligament, alveolar bone, and buccal tube, were established. The models were divided into the McLaughlin-Bennett-Trevisi (MBT™) straight-wire model with 0-degree maxillary first molar axial inclination and the physiologic anchorage Speewire system (PASS) model with -7-degree maxillary first molar axial inclination. Simulated sliding retraction forces (1 N, 1.5 N, and 2 N) were loaded on the buccal side and lingual side, and retraction forces (0.5 N, 0.75 N, and 1 N) were loaded on the buccal and lingual sides simultaneously. The displacements, principal stresses, and von Mises stresses of the periodontal ligament under different conditions were derived. Results: The anchorage molars showed different degrees of rotation, tipping, intrusion, and extrusion. As the force increased, these displacement trends also increased. The mesial displacement of the buccal + lingual force loading was less than that of the other two groups. Under the same force load method, the mesial displacement of the PASS group was less than that of the MBT group. Tilt movement increases the tensile stress of the distal cervical margin and root mesial apical third and the compressive stress of the mesial cervical margin and root distal apical third. The maximum stress of the periodontal ligament was less than that of the other two groups when the lingual force was loaded. Conclusion: The physiological anchorage control concept in lingual orthodontics provides better sagittal anchorage control than in labial orthodontics, but there is no significant difference numerically. Attention should be given to the control of torsion, torque, and arch width. Tilt movement increases the PDL stress of the cervical margin and root apical third. The sliding retraction force should be loaded lingually to maintain the force value of 1∼1.5 N.