Abstract:Resonant enhancement of nonlinear photonic processes is critical for the scalability of applications such as long-distance entanglement generation. To implement nonlinear resonant enhancement, multiple resonator modes must be individually tuned onto a precise set of process wavelengths, which requires multiple linearly-independent tuning methods. Using coupled auxiliary resonators to indirectly tune modes in a multi-resonant nonlinear cavity is particularly attractive because it allows the extension of a single physical tuning mechanism, such as thermal tuning, to provide the required independent controls. Here we model and simulate the performance and tradeoffs of a coupled-resonator tuning scheme which uses auxiliary resonators to tune specific modes of a multi-resonant nonlinear process. Our analysis determines the tuning bandwidth for steady-state mode field intensity can significantly exceed the inter-cavity coupling rate if the total quality factor of the auxiliary resonator is higher than the multi-mode main resonator. Consequently, over-coupling a nonlinear resonator mode to improve the maximum efficiency of a frequency conversion process will simultaneously expand the auxiliary resonator tuning bandwidth for that mode, indicating a natural compatibility with this tuning scheme. We apply the model to an existing small-diameter triply-resonant ring resonator design and find that a tuning bandwidth of 136 GHz ~ 1.1 nm can be attained for a mode in the telecom band while limiting excess scattering losses to a quality factor of 10^6. Such range would span the distribution of inhomogeneously broadened quantum emitter ensembles as well as resonator fabrication variations, indicating the potential for the auxiliary resonators to enable not only low-loss telecom conversion but also the generation of indistinguishable photons in a quantum network.

Nonlinear response of very high frequency contour mode resonators

Modeling Of Nonlinear Response From Metallic Metamaterials By Maxwell-Hydrodynamic Equations

Impact of Nonlinear Effects on the Silicon-Based Waveguides and Microring Resonators

Characterizing multi-mode nonlinear dynamics of nanomechanical resonators

Probing Linear to Nonlinear Damping in 2D Semiconductor Nanoelectromechanical Resonators Toward a Unified Quality Factor Model.

Nonlinear Damping and Quality Factor in 2d Molybdenum Disulfide Nems Resonators at Varying Electrical Drive

Perturbation analysis of nonlinear responses caused by transverse modes in AlN FBAR based on 2D scalar wave model

Nonlinear effects in locally-resonant nanostrip phononic metasurface at GHz frequencies

Generalized frequency shift and attenuation in simply-supported micro/nano-beam resonators with thermoelastic dissipation

Nanoscale imaging of super-high-frequency microelectromechanical resonators with femtometer sensitivity

A Study on the Effects of Bottom Electrode Designs on Aluminum Nitride Contour-Mode Resonators

Hyperbolic resonant radiation of concomitant microcomb induced by cross-phase modulation

Integrated High-Q Crystalline AlN Microresonators for Broadband Kerr and Raman Frequency Combs

Amplitude Deflection in a Nonlinear MEMS Resonator under Parametric Excitation

Integrated high frequency aluminum nitride optomechanical resonators

Theoretical Insights into 1:2 and 1:3 Internal Resonance for Frequency Stabilization in Nonlinear Micromechanical Resonators

Field-Circuit Co-Simulation for Microwave Metamaterials with Nonlinear Components

Mode-Dependent Scaling of Nonlinearity and Linear Dynamic Range in a NEMS Resonator

Selective active resonance tuning for multi-mode nonlinear photonic cavities

P1J-5 Spurious Modes in Aluminum Nitride Film Resonators

Nonlinearities in a high-Q SOI Lamé-mode bulk resonator