Abstract:Abstract Background The progressive evolution in hip replacement research is directed to follow the principles of bone and soft tissue sparing surgery. Regarding hip implants, a renewed interest has been raised towards short uncemented femoral implants. A heterogeneous group of short stems have been designed with the aim to approximate initial, post-implantation bone strain to the preoperative levels in order to minimize the effects of stress shielding. This study aims to investigate the biomechanical properties of two distinctly designed femoral implants, the TRI-LOCK Bone Preservation Stem, a shortened conventional stem and the Minima S Femoral Stem, an even shorter and anatomically shaped stem, based on experiments and numerical simulations. Furthermore, finite element models of implant–bone constructs should be evaluated for their validity against mechanical tests wherever it is possible. In this work, the validation was performed via a direct comparison of the FE calculated strain fields with their experimental equivalents obtained using the digital image correlation technique. Results Design differences between Trilock BPS and Minima S femoral stems conditioned different strain pattern distributions. A distally shifting load distribution pattern as a result of implant insertion and also an obvious decrease of strain in the medial proximal aspect of the femur was noted for both stems. Strain changes induced after the implantation of the Trilock BPS stem at the lateral surface were greater compared to the non-implanted femur response, as opposed to those exhibited by the Minima S stem. Linear correlation analyses revealed a reasonable agreement between the numerical and experimental data in the majority of cases. Conclusion The study findings support the use of DIC technique as a preclinical evaluation tool of the biomechanical behavior induced by different implants and also identify its potential for experimental FE model validation. Furthermore, a proximal stress-shielding effect was noted after the implantation of both short-stem designs. Design-specific variations in short stems were sufficient to produce dissimilar biomechanical behaviors, although their clinical implication must be investigated through comparative clinical studies.

Numerical simulation and analysis of fatigue performance for the humeral stem

Fatigue Analysis of Hip Prosthesis

Endurance testing and finite element simulation of a modified hip stem for integration of an energy harvesting system

Stress Analysis and Shape Design of a Femoral Hip Prosthesis

[Analysis on Morphology and Stability of Femoral Hip Prosthesis Based on the Revision Operation].

Experimental analysis and numerical fatigue life prediction of 3D-Printed osteosynthesis plates

Numerical Investigation of Fatigue Behavior in Ti-6Al-4V Orthopedic Hip Implants Subjected to Different Environments

Failure Analysis of a Humeral Shaft Locking Compression Plate—Surface Investigation and Simulation by Finite Element Method

Porous versus solid shoulder implants in humeri of different bone densities: A finite element analysis

Numerical investigation on the wear characteristics of hip implant under static loading

Residual stress prediction in a powder bed fusion manufactured Ti6Al4V hip stem

Comparative analysis of the biomechanical behavior of two different design metaphyseal-fitting short stems using digital image correlation

In-silico modelling of multi-strike insertion and torsional resistance of tapered revision hip stems: Insight into spline design philosophy

Optimizing functionally graded tibial components for total knee replacements: a finite element analysis and multi-objective optimization study

Two-dimensional finite element simulation of fracture and fatigue behaviours of alumina microstructures for hip prosthesis

Fatigue Life Estimation of 2(3HUS+S) Parallel Manipulator for Simulation of Hip Joint Motion.

Strategic Debulking of the Femoral Stem Promotes Load Sharing Through Controlled Flexural Rigidity of the Implant Wall: Optimization of Design by Finite Element Analysis

Theoretical and Numerical Analysis of the Fatigue Strength of Mechanical Material and Part under Uniaxial Stress

Finite element analysis part 2 of 2: Glenohumeral bone stress distribution depends on implant configuration for anatomic and reverse stemless shoulder implants

The mean stress and phase angle effect on multiaxial fatigue behavior of a TiAl alloy: Failure analysis and life modeling

Numerical Simulation of Low Cycle Fatigue Behavior of Ti2AlNb Alloy Subcomponents