Abstract:The production of thermoluminescence (TL) dosimeters fabricated from B2O3-Caf2-Al2O3-SiO2 doped with Cu and Pr for use in diagnostic radiology is the main goal of this research. The TL samples were synthesized via the melt-quench technique processed by melting the mixture at 1200 °C for 1 h, and, after cooling, the sample thus created was divided into two samples and retreated by heating for 2 h (referred to as TLV30) and for 15 h (referred to as TLV17). SEM and EDS analyses were performed on the TL samples to confirm the preparation process and to investigate the effects of irradiation dosimetry on the TL samples. Furthermore, the TL samples were irradiated with γ-rays using a 450 Ci 137Cs irradiator and variable X-ray beams (5–70 mGy). Two important diagnostic radiology applications were considered: CT (6–24 mGy) and mammography (2.72–10.8 mGy). Important dosimetric properties, such as the glow curves, reproducibility, dose–response linearity, energy dependence, minimum dose detectability and fading, were investigated for the synthetized samples (TLV17 and TLV30), the results of which were compared with the Harshaw TLD-100. The TLV17 dosimeter showed higher sensitivity than TLV30 in all applied irradiation procedures. The dose–response linearity coefficients of determination R2 for TLV17 were higher than TLD-100 and TLV30 in some applications and were almost equal in others. The reproducibility results of TLV17, TLV30 and TLD-100 were less than 5%, which is acceptable. On the other hand, the results of the fading investigations showed that, in general, TLV17 showed less fading than TLV30. Both samples showed a significant decrease in this regard after the first day, and then the signal variation became essentially stable though with a slight decrease until the eighth day. Therefore, it is recommended to read the TL dosimeters after 24 h, as with TLD-100. The SEM images confirmed the existence of crystallization, whilst the EDS spectra confirmed the presence of the elements used for preparation. Furthermore, we noticed that TLV17 had grown dense crystals that were larger in size compared to those of TLV30, which explains the higher sensitivity in TLV17. Overall, despite the fading, TLV17 showed greater radiation sensitivity and dose–response linearity compared with TLD-100. The synthetized TL samples showed their suitability for use as dosimeters in diagnostic radiology radiation dosimetry.

A custom-made integrated system for thermoluminescence and radioluminescence spectroscopy

A high sensitivity system for luminescence measurement of materials

OSL and PTOSL of dosimetric materials: Observation of the luminescence after exposure to 90 Sr+ 90 Y source and LEDs in ultraviolet range

Thermoluminescent characteristics of LiF:Mg,Cu,P and CaSO$_4$:Dy for low dose measurement

Spotlight on Luminescence Thermometry: Basics, Challenges, and Cutting‐Edge Applications

Ca2Na2La6(SiO4)4(PO4)2O: Eu2+/Eu3+: A Visual Dual‐emitting Fluorescent Ratiometric Temperature Sensor

Dosimetry at the Portuguese research reactor using thermoluminescence measurements and Monte Carlo calculations

High-sensitivity Ratiometric Thermometers of Yb3+/Er3+/Tm3+ Co-Doped LuScO3 Single Crystal Fibers Based on Non-Thermally Coupled Energy Levels

Sensitive Fibre-Based Thermoluminescence Detectors for High Resolution In-Vivo Dosimetry

Development of Ag-Doped ZnO Thin Films and Thermoluminescence (TLD) Characteristics for Radiation Technology

On LiF:Mg,Cu,P and LiF:Mg,Ti phosphors high & ultra-high dose features

Dosimetric Study of Heat-Treated Calcium–Aluminum–Silicon Borate Dosimeter for Diagnostic Radiology Applications

Dosimetry of ultra-high dose rate electron beams using thermoluminescence and optically stimulated luminescence detectors

Lanthanide‐Based Thermometers: At the Cutting‐Edge of Luminescence Thermometry

Uncertainty of LiF thermoluminescence at low dose levels: Experimental results

Towards accurate real-time luminescence thermometry: an automated machine learning approach

Radiophotoluminescence response of LiF:Mg,Ti pellets irradiated with clinical proton beams in the 70-200 MeV energy range

Thermoluminescence as a Research Tool to Investigate Luminescence Mechanisms

Effect of IRSL-BLSL-TSL reading modes combination on thermoluminescence (TL) response of BeO dosimeter

TL properties of RE-Doped and Co-doped Sol-gel Silica Rods. Application to Passive (OSL) and Real-time (RL) Dosimetry

Studies on Radioluminescence Dose-Rate Measurement Based on LiF:Mg,Ti and SiPM