Enhancing Cr(vi) removal performance of Ti3C2T x through structural modification by using a spray freezing method

Linjie Yi,Hongwei Wang,Xianliang Ren,GaoBin Liu,Hongen Nian,Zhiqin Zheng,Fang Wu
DOI: https://doi.org/10.1039/d4ra04640d
2024-09-05
Abstract:Structural modification is expected to be a facile way to enhance the adsorption performance of MXene. In this work, the structural modification of Ti3C2T x was carried out by a spray freezing method, and two kinds of nano-structure (spherical and flaky) of Ti3C2T x were prepared by adjusting the solution concentration of Ti3C2T x . Then the Cr(vi) adsorption capacity and removal efficiency of the spherical and flaky Ti3C2T x was investigated, respectively. It is found that flaky Ti3C2T x was produced with a Ti3C2T x concentration of 3 mg mL-1, while spherical Ti3C2T x was obtained with a concentration of 6 mg mL-1. The long diameter of flaky Ti3C2T x is about 8-10 μm, and the specific surface area is 17.81 m2 g-1. While spherical Ti3C2T x had a diameter of about 1-4 μm and a specific surface area of 17.07 m2 g-1. The optimized structure of flaky and spherical Ti3C2T x improves the maximum adsorption capacity by 97% and 33%, respectively, compared with the few-layer Ti3C2T x . The maximum adsorption capacity of flaky Ti3C2T x was 928 mg g-1, while that of spherical Ti3C2T x was 626 mg g-1. The adsorption capacity of both Ti3C2T x structures decreased with the increase of pH, and reached the maximum value at pH = 2; meanwhile, the adsorption capacity of both Ti3C2T x structures increased with the increase of Cr(vi) concentration. The adsorption of Cr(vi) on flaky Ti3C2T x was very fast, reaching equilibrium in 3 min, while spherical Ti3C2T x took 5 min. The adsorption of Cr(vi) on both Ti3C2T x structures belonged to the monolayers, heat-absorbing chemical adsorption, and the diffusion process of Cr(vi) was regulated by the external diffusion and internal diffusion of particles. Its adsorption mechanism was the combination of reductive adsorption and electrostatic adsorption.
What problem does this paper attempt to address?