Abstract:Pipe cable is considered as an important form for underground transmission line. The maximum electrical current (ampacity) of power cable system mostly depends on the cable conductor temperature. Therefore, accurate calculation of temperature distribution in the power cable system is quite important to extract the cable ampacity. In the present paper, the fluid flow and heat transfer characteristics in the pipe cable with alternating current were numerically studied by using commercial code COMSOL MULTIPHYSICS based on finite element method (FEM). The cable core loss and eddy current loss in the cable were coupled for the heat transfer simulation, and the difference of heat transfer performances with pure natural convection model and radiation-convection model was compared and analysed in detail. Meanwhile, for the radiation-convection model, the effects caused by radiant emissivity of cable surface and pipe inner surface, as well as the cable location in the pipe, were also discussed. Firstly, it is revealed that the radiation and natural convection heat flux on the cable surface would be of the same order of magnitude, and the radiation heat transfer on the cable surface should not be ignored. Otherwise, the cable ampacity would be underestimated. Secondly, it is found that the overall heat transfer rate on the cable surface increases as the cable surface emissivity increases, and this is more remarkable to the upper cable. While the effect caused by the radiant emissivity on the pipe inner surface would be relatively small. Furthermore, it is demonstrated that, as cable location in the pipe falls, the natural convection heat transfer would be enhanced. These results would be meaningful for the ampacity prediction and optimum design for the pipe cable.

Numerical and experimental analysis of thermal behaviour of high voltage power cable in unfilled ducts

Coupled Thermal-Electrical Analysis of 110 Kv Corrugated Aluminum Sheathed and Smooth Aluminum Sheath Cables Based on Finite Element Simulation Method

Numerical Analysis of Thermo-Electric Field for AC XLPE Cables with Different Service Times in DC Operation Based on Conduction Current Measurement

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

Numerical Calculation of Real-Time Ampacity of High Voltage Power Cable Duct Laying Based on Environmental Information

Numerical Study of Convection and Radiation Heat Transfer in Pipe Cable

Numerical analysis of thermo-electric field for 10 kV AC XLPE cable in DC operation

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Numerical Study of Heat Transfer in Underground Power Cable System

Underground MV power cable joints: A nonlinear thermal circuit model and its experimental validation

Study On The Numerical Method Of Thermal Distribution In 3-Phase Cable Terminal

Numerical and experimental research on electromagnetic-thermal and leakage defects characteristics of the high voltage cable terminal

Simulation Analysis of Electromagnetic and Heat Field Distribution in 330kv High Voltage AC Cable

Investigation of Heat Dissipation of Power Cable Laid in the Tunnel with Ventilation

Study on Finite Element Analysis of the External Heat Resistance of Cables in Ductbank

Research on thermomechanical effects and influencing factors in high voltage cable under multiphysics field coupling

Evaluation of the power frequency magnetic field generated by three-core armored cables through 3D finite element simulations

Numerical modelling of MgB2 conductors for high power AC transmission

A Method of Temperature Calculation of Power Cable Conductor

Modeling Thermal Distribution of Three-core XLPE Dynamic Cable under Mechanical Loads

Thermal Resistance Properties of the Part between Metal Sheath and Conductor in High-voltage Power Cable