Abstract:This brief presents a low phase noise class-C voltage-controlled oscillator with bond wire inductors. To improve the Q-factor of inductors, the voltage-controlled oscillator employs bond wires as the inductors of the resonators. A transient-analysis-compatible equivalent circuit is proposed to precisely estimate the influence of mutual inductance, parasitic components and silicon substrate. Possible phenomena of oscillation mode ambiguity and oscillation failure are analyzed to be relative with the magnetic coupling between bond wires. An equation is derived to set up the relation among oscillation mode, bond wire coupling and frequency ratio of adjacent oscillators. And a costless placement reorder method is proposed to prevent the oscillator cores from oscillating failure and mode ambiguity. The voltage-controlled oscillator is implemented in a 65-nm CMOS process. Ten groups of gold double bond wires with a 20 $\mu \text{m}$ diameter, 70 $\mu \text{m}$ height and 800 $\mu \text{m}$ horizontal length are adopted as the inductors. The total tuning range of the oscillator is from 2.22 GHz to 4.46 GHz. When oscillating at 4.46 GHz and the output frequency divide ratio is 2, the output signal provides phase noise performance of −137.3 dBc/Hz at 1 MHz offset from 2.23 GHz. The maximum power consumption is 38 mW and each oscillator core occupies a chip area of only 0.112 mm 2 .

A Voltage-Controlled Surface Acoustic Wave Oscillator based on Lithium Niobate on Sapphire Low-Loss Acoustic Delay Line

A 0.8 V Low Power Low Phase-Noise Pll

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A 60GHz voltage-controlled oscillator with a 3.6GHz tuning range in 180nm CMOS technology

Low-phase-noise surface acoustic wave oscillator using phononic crystal bandgap-edge mode

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A 300-500 MHz Tunable Oscillator Exploiting Ten Overtones in Single Lithium Niobate Resonator

A broadband CMOS LC voltage-controlled oscillator for FMCW synthesizer

A Low Phase-Noise LC Voltage Controlled Oscillator in CMOS Technology

SIW-based low phase-noise millimeter-wave planar dual-port voltage-controlled oscillator

A 1.8-V 2.4/5.15-Ghz Dual-Band LCVCO in 0.18-/Spl Mu/m CMOS Technology

A Voltage-Controlled Oscillator with an Ultra-Low Supply Voltage and Its Application to a Fractional-N Phase-Locked Loop

A 5-8 GHz Wideband and Low Phase Noise Cross-Coupled LC VCO Using 6-bit DCCA in 40nm CMOS Process

A 2.7-Mw 1.36–1.86-Ghz LC-VCO with a FOM of 202 Dbc/hz Enabled by a 26%-Size-reduced Nano-Particle-Magnetic-Enhanced Inductor

A Spurious-Free SAW Resonator with Near-Zero TCF Using LiNbO3/SiO2/quartz

A 4.9–6.9 GHz LC VCO with low-phase-noise

Optimization and Realization of a 315-Mhz Low-Phase-Noise Voltage-Controlled SAW Oscillator

An Ultra-Low Phase Noise 1.6ghz 65nm Class-B RF-VCO with -139.44Dbc/hz @1mhz Offset

Design and Fabrication of Low Phase Noise Oscillator Using $Q$ Enhancement of the SISL Cavity Resonator

Heterogeneous Integration of 42°YX LiNbO3/SiO2/Quartz for Wideband and Spurious-Free SAW Resonators