Abstract:The contamination of water resources by emerging contaminants, such as heavy metals and textile effluents, poses significant ecological and human health risks. Conventional effluent treatment plants may not effectively degrade all types of pollutants, resulting in the contamination of natural water resources. Photocatalysis, specifically the photo-Fenton reaction, has emerged as an efficient sustainable cost-effective method for the removal of pollutants. In this study, three batches (CF-1, CF-2, and CF-3) of copper ferrite nanoparticles (NPs) were synthesized and used as photocatalysts for the degradation of methylene blue (MB) dye and reduction of hexavalent chromium (Cr(VI)) under visible light. The CF-1, CF-2, and CF-3 required (90, 75, and 60 min.) different periods to reach a nearly similar degradation percentage, i.e., 90%, wherein the CF-3 batch demonstrated better catalytic activity. The successful synthesis of copper ferrite NPs was confirmed by XRD analysis which reveals the CuFe 2 O 4 phase. With the increased concentration of copper, the formation of the CuO phase alongside the CuFe 2 O 4 phase was observed. The CF-3 catalyst had a surface area of 44.496 m 2 /g according to BET studies. The catalyst exhibited a pore radius of 19.175 Å and an adsorption pore volume of 0.109 cc/g, as determined by the BJH method. TEM micrographs showed spherical-shaped NPs with sizes ranging from 55 to 60 nm. The photo-Fenton process was optimized by varying dye concentration, pH, catalyst, and hydrogen peroxide (H 2 O 2 ) dosages for MB degradation. The scavenger study reveals the contribution of the •OH radical over •O 2 − radical in the photo-Fenton process for MB degradation. The reduction of Cr(VI) was optimized by adjusting pH and Cr load. The CF-3 catalyst exhibited almost complete degradation of MB (32 mg/L) within 60 min and reduction of Cr(VI) (100 mg/L) within 20 min. The good reusability of the catalyst exhibits 71.4% MB degradation after four cycles and 78.34% Cr(VI) reduction after five cycles. The regression coefficient ( R 2 ) of the pseudo-second-order reaction was close to 1 and higher than the pseudo-first-order reaction. The catalyst achieved 0.0540 and 0.1047 1/min kinetic constant at pseudo-first-order reaction, while 0.0614 and 0.0497 L/mg.min kinetic constant was achieved at pseudo-second-order reaction for MB degradation and Cr(VI) reduction. These kinetic studies proved that the dye degradation and chromium reduction follow the pseudo-second-order reaction ( R 2 ). The overall study demonstrates the promising potential of magnetic CF-3 nanoparticles as efficient catalysts for industrial applications in dye degradation and Cr(VI) reduction.

Fabrication and catalytic activity of TiO2/Fe3O4 and Fe3O4/β-cyclodextrin nanocatalysts for safe treatment of industrial wastewater

Enhanced Conversion from H2O2 to 1O2 on Cu–N Centers: Investigation of Mechanisms and Application in Alkaline Wastewater Treatment

Fabrication of Fe2O3/TiO2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Fabrication of Fe<SUB>2</SUB>O<SUB>3</SUB>/TiO<SUB>2</SUB> Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Treatment of water and effluents from methylene blue dye by using high-performance Fe3O4/rGO/ZnSe/TiO2 magnetic nanocomposite

Synergistic Effect of Iron and Copper Oxides in the Removal of Organic Dyes Through Thermal Induced Catalytic Degradation Process

Efficient degradation of tetracycline by activated peroxymonosulfate with high permeate flux FeTiO x reactive ceramic membrane: Membrane preparation, real wastewater application, and mechanism insight

Enabling highly concentrated tetracycline degradation with tailored FeCo nanocrystals in porous graphitic carbon fiber

Catalytic and kinetic studies of CuFe2O4 as a superior heterogeneous nanocatalyst for dye degradation and Cr(VI) reduction

Electrospun Fe doped TiO2 fiber photocatalyst for efficient wastewater treatment

Nanostructured Iron Oxides: Structural, Optical, Magnetic, and Adsorption Characteristics for Cleaning Industrial Effluents

Preparation of magnetite nanoparticles and their application in the removal of methylene blue dye from wastewater

Innovative treatment of industrial effluents through combining ferric iron and attapulgite application

Efficient Removal of Organic and Inorganic Pollutants from Water Using Fe3O4@SiO2@CS@EDTA Nanocomposite: Optimization via Response Surface Methodology (RSM)

Experimental overview of nanoferrites: synthesis, characterization and performance evaluation in wastewater treatment

In-situ preparation of yeast-supported Fe0@Fe2O3 as peroxymonosulfate activator for enhanced degradation of tetracycline hydrochloride

A novel Fe 3 O 4 @Pt synthetized via a self-assembly strategy as efficient Fenton-like@mimetic enzyme catalyst for degradation of tetracyclines in food processing wastewater

Photocatalytic degradation of textile dyes laden industrial wastewater using fabricated bismuth ferrite coated nickel/nickel oxide foam

High-efficiency removal of antibiotic pollutants by magnetic carbon aerogel: Inherent roles of adsorption synergistic catalysis

Tribocatalytic Degradation of Organic Pollutants Using Fe 2 O 3 Nanoparticles

Highly efficient degradation of basic dyes using gold-coated nature-based supermagnetic iron oxide nanoparticles as eco-friendly nanocatalysts