Abstract:The global increase in population and rapid urbanization has been followed by a growing generation of municipal solid wastes and construction and demolition sector wastes. This has put increasing pressure on countries around the world to come up with sustainable ways to deal with issues related to waste generation, climate change, and social and environmental degradation. This paper investigates a novel means of co-utilization of municipal solid wastes (MSW) with gypsum wastes from the construction and demolition sector for energy recovery and materials recycling and explores synergistic improvement in their processed value. We investigated high-temperature pyrolysis and gasification under different gasifying environments of inert (N 2 ), 10 % O 2 , 20 % CO 2 , and 70 % H 2 O at two different temperatures of 800 and 900 °C, in a semi-batch fixed bed reactor. Syngas obtained was analyzed for its composition and yield, while the solid residue obtained was analyzed for the crystalline phases of the inorganic content using powder-XRD (X-ray diffraction) diagnostics. These analyses revealed that increasing temperature as well as the addition of gypsum can significantly improve the carbon conversion and overall product gas yields. When comparing the gasifying environments, steam gasification provided increased syngas mass yields by up to 184 %, 425 % and 377 % respectively, as compared to CO 2 gasification, O 2 gasification, and pyrolysis environments. Adding gypsum at equal mass proportions (1:1) to MSW pyrolysis at 900 °C increased the syngas yield by 10 % compared to the non-catalytic case, while adding it at 800 °C reduced syngas yield by 6 % compared to the non-catalyzed pyrolytic case at 800 °C. Adding gypsum during O 2 gasification increased the syngas yield by 25 % compared to the non-catalytic cases at 900 °C and increased by 12.5 % at 800 °C. However, the syngas yield was reduced by 84 % when gypsum was added at equal mass proportions (1:1) to steam gasification of MSW at 900 °C and 50 % for 800 °C. Adding gypsum to CO 2 gasification also reduced the cumulative yield of syngas for both temperatures under investigation. However, the syngas quality was improved with gypsum addition as the yields of hydrocarbon were reduced. The char/solid residue was found to contain significant portions of CaS suggesting sulfur fixation capability of this process into the ash which can improve the ash characteristics in terms of metal recovery along with the improved waste conversion.

FGD-Gypsum Waste to Capture CO2 and to Recycle in Building Materials: Optimal Reaction Yield and Preliminary Mechanical Properties

Carbon sequestration through mineral carbonation: Using commercial FGD-gypsum from a copper smelter for sustainable waste management and environmental impact mitigation

CO2 Capture and Process Reinforcement by Hydrolysate of Phosphogypsum Decomposition Products

Procedure to use phosphogypsum industrial waste for mineral CO2 sequestration

Acid leaching technology for post-consumer gypsum purification

Recycling of Waste Gypsum in Preparation of Magnesium Oxychloride Cement (MOC)

The production of artificial aggregates with flue gas desulfurization ash: Development of a novel carbonation route

Effect of impure components in flue gas desulfurization (FGD) gypsum on the generation of polymorph CaCO3 during carbonation reaction

Valorization of Acid Leaching Post-Consumer Gypsum Purification Wastewater

Enhanced Carbon Sequestration Via Phosphogypsum Utilization in Conjunction with Concrete Wastewater Treatment

Preparation of high-performance building gypsum by calcining FGD gypsum adding CaO as crystal modifier

Preparation of calcium carbonate by indirect carbonation desulfurization gypsum with renewable aspartic acid

Gasification of municipal solid wastes with gypsum wastes under different gasifying environments

Experimental Studies on Decomposing Properties of Desulfurization Gypsum in a Thermogravimetric Analyzer and Multiatmosphere Fluidized Beds

Eco-friendly construction materials: new gypsum-based composite with dregs waste from the cellulose industry

Reusing Construction and Demolition Waste to Prepare Alkali-Activated Cement

Dehydration of gypsum waste to recyclable anhydrite using a nano-film reservoir under ambient conditions

Porous Materials Composed of Flue Gas Desulfurization Gypsum and Textile Fiber Wastes

Modification of FGD Gypsum in Hydrothermal Mixed Salt Solution.

The use of fly ashes from waste-to-energy processes as mineral CO2 sequesters and supplementary cementitious materials

A sustainable temperature-swing process for CO2 capture and mineralization at below 100 °C using a recyclable chelating agent and bottom ash