Stochastic modeling of light scattering applied in remote sensing and ballistic-photon imaging
Milos Sormaz
DOI: https://doi.org/10.3929/ethz-a-006385628
Abstract:Although the analytical theory provides an accurate solution of light-matter interaction, its complexity and high computational cost limits its application in many fields where highly heterogeneous media are of interest (e.g. atmospheric science, biomedical optics, oceanography etc). The need for a simpler and less expansive approach caused the development of the transport theory based on the Boltzmann equation for either the light intensity or the Stokes vector, which is usually solved using Monte Carlo methods. This thesis provides a novel method, so-called stencil algorithm, for the transport of light in heterogeneous media based on the Monte Carlo method for both, scalar and vector waves. It is applied for various problems of remote sensing were different properties are computed (e.g. an optical dot gain in halftone prints and backscattering Mueller matrices). High quality halftone printing is performed using a paper with fluorescent additives, which absorb light in the ultraviolet part of the spectrum and emits radiation mostly in the blue part of the visible spectrum. Thereby, a fluorescence model is incorporated in the stencil algorithm. Calculated reflectance from the halftone prints are validated with the measurements performed using microscope, i1 and Spectrolino. The illumination and detection geometries of considered devices are different, which gives different optical dot gains whose accurate prediction validates the fluorescence model and calculated scattering and absorption properties of paper and ink. In order to compute backscattering Mueller matrices, polarization is incorporated in both Monte Carlo method and stencil algorithm. Model and implementation are validated by comparing the results obtained with both methods, while the significant speedup is achieved by the stencil algorithm. Recently, in clinical applications there is a large requirement for computation of material properties of biological tissues which posses linear birefringence. Calculated backscattering Mueller matrices of such media are compared with the measured ones. In these calculations the assumption that linear birefringence has no influence in the computation of a single-scattering phase function is employed. Numerical study is performed to show the limitations of this assumption, since the input to the used Lorenz-Mie theory involves other parameters of the scattering spheres, like their radius and refractive index. Finally, the developed Monte Carlo implementation, named Scatter3D, is used to improve contrast in ballistic-photon imaging using a polarization-gating technique. Considered scattering media are typical for biomedical optics and are designed to mimic realistic biological tissues. Such media, composed of spherical scattering particles (e.g. polystyrene or TiO spheres) embedded in homogeneous, isotropic background medium (e.g. silicon or distilled water), allow use of the Lorenz-Mie theory of light scattering. It is shown that the contrast curves and possible improvement using polarization gating are highly affected by the single-scattering phase function.
Physics,Environmental Science