Abstract:Confined and submerged two-phase jet impingement offers a compact and effective heat transfer technology for thermal management. In contrast to free-surface jets, few studies have investigated the critical heat flux phenomenon during confined and submerged jet impingement. In this study, the impact of jet velocity on critical heat flux is examined during confined and submerged impingement of a water jet. A single jet issues through a 3.75 mm-diameter orifice and impinges on a circular 25.4 mm-diameter heated surface. The jet velocity is varied between 0.30–1.62 m/s ( Re ≈ 3500–20,000) with the height of the confinement gap held equal to the jet diameter at 3.75 mm. The two-phase flow morphology is observed via high-speed visualization from the top of the confinement gap, and the transient pressure drop across the jet orifice and flow gap is measured simultaneously. Critical heat flux increases monotonically with velocity from 104 W/cm 2 to 275 W/cm 2 over the tested velocity range. As with free-surface jet impingement, two regimes can be identified: a low-velocity regime and a velocity-dominated regime. However, the observed critical heat fluxes for the confined and submerged jet are 32 % to 16 % lower than those predicted for a free-surface jet configuration. This curtailment of critical heat flux is related to disturbances in the incoming liquid flow induced by dynamics of the two-phase flow in the confinement gap, as indicated by large, recorded pressure drop oscillations. These flow and pressure oscillations are attenuated by the jet momentum with increasing velocity, as corroborated by high-speed flow visualizations. In the low-velocity regime, there are significant effects of these two-phase interactions in the confinement gap. Close to critical heat flux, brief periods occur when vapor completely obstructs the jet orifice, during which a significant portion of the heated surface dries out. In the velocity-dominated regime, at higher jet velocities, the two-phase flow disturbances cause observable instances of mild reduction in the flow rate of the incoming liquid jet, which are followed by dry out of small regions on the periphery of the heated surface. Flow visualizations during the transition to film boiling indicate that premature dry out of the heated surface is induced by these flow and pressure oscillations.

Visualization of Flow and Heat Transfer Augmentation by Oblique Impingement Jets

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Numerical Study on Heat Transfer of an Impinging Turbulent Plane Jet with Confined Wall.

A Review on Experimental and Numerical Investigations of Jet Impingement Cooling Performance with Nanofluids

Numerical Study on Flow and Heat Transfer Characteristics of 3D Turbulent Impinging Jets

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

Flow and heat transfer studies of multijet impingement cooling for different configurations: A review

The suppressive effect of supraoptimum doses of antigen on the secondary antibody-forming response of spleen cells cultured in cell-impermeable diffusion chambers.

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

Adjoint shape optimization for enhanced heat transfer in sweeping jet impingement on concave surface

Experimental and Numerical Study of Jet Impingement Cooling for Improved Gas Turbine Blade Internal Cooling With In-Line and Staggered Nozzle Arrays

Influence of Jet Impingement Configurations and Aerothermal Variables on Film Cooling

Heat transfer and fluid dynamics of a single jet impingement – An experimental and numerical approach

Experimental and Numerical Investigations of Extended Jet Effects on Multiple-Jet Impingement Heat Transfer Characteristics

An augmented swirling and round jet impinging on a heated flat plate and its heat transfer characteristics

Numerical Simulation of the Flow and Heat Transfer Characteristics of Sweeping and Direct Jets on a Flat Plate with Film Holes

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Critical heat flux degradation due to flow disturbances and pressure oscillations under confined and submerged two-phase water jet impingement

Thin liquid film flow and heat transfer under spray impingement

Experimental and numerical study of the anti-crossflows impingement cooling structure